I have a Cisco 3850. I have read the discussions on whether or not they do NAT. It appears people have got them to do so. I am needing mine to nat between 192.168.125.x(inside) and 10.10.9.x.(outside). I am needing to be able to hit a device on t...
Forum Posts
Hi All, Is it possible to access the internet connection through a VPN? Router B(WAN2) connects to Router A(WAN2) via ethernet cable with a VPN tunnel. router A(WAN1) connects to ISP fiber broadband. Router B WAN1 is not connected to any ISP. Will ...
Why does the Dialer interface show LCP as closed, but on the Virtual-Access interface LCP shows up as open?Also, is it normal for the NCPs to only show up under the Virtual-Access interface? What is the reasoning for this? sh int di1Dialer1 is up, li...
Hola, actualmente tengo la necesidad de configurar la red particionada en 3 redes mediante VLAN,s mediante en CISCO SG300-10 y la configuración actual que necesitaría es: VLAN2 red de 2 impresoras. Sin acceso a internet VLAN3 red de TV con acceso a ...
Hello all,I've looked around and there seem to be very little info when configuring this, but apologies if I missed this, and this is also my first post so my bad if this is explained poorly but my goal is this:- bt adsl terminating to 4321 with NIM-...
Hello Cisco community,I was wondering how can I use VPN from phone?I did the configuration but I don't know how to test or whether the configuration is correct or not,find the attached Zip fileplease help Thanks in advance
Resolved! Ipv6 route
Hi Can anyone explain why is this route installed in ipv6 RIB?L FF00::/8 [0/0] via Null0, receive ThanksSiva
Hello,I was studying on bgp performance and I came across "bgp fast-external-fallover" and BFD. I am confused because both achieve the exact same thing. Could anyone please let me know when we should "bgp fast-external-fallover" over BFD or vice vers...
Hi , I need an access for Cisco anyconnect secure mobility client. so kindly suggest me to get an access. Thank you, Sai Charan
Hello I am looking into extending 2 VLAN separated in 2 VRF's on premise, to Azure using VTI based IKEv2 VPN with 2 routers (Cisco ISR), each connected to different ISP. please refer to attached drawing... I am unsure if this is possible - could some...
Anyone here have experience using Automatic Transfer Switch power supplies for Cisco ISR 4000 routers?We want to use RPS for a/b AC power delivery but it’s not supported on the low-end models.The RPS states 60 μs switchover. We found an APC ATS but i...
Hello,can anybody please give me a hint how many OSPF areas an ISR4331 router supports?Thank you in advance!
I am trying to get a sense of best practice approach here. Currently have two data centers that are connected to my branch offices via BGP into the ISP network. The plan is to send all default route traffic to one Data Center to get to the internet a...
I would like to make backups of my cisco devices using SCP from a linux filesystem. I am running the following command:scp username@192.168.1.1:flash/ /dir/to/backup...where 192.168.1.1 is the cisco device's IP. I get the following response to the ...
Hello all.i have recently had to change my network so now my RV325 is sat behind a Mitel Boarder Gateway in network edge mode. The WAN address is now on the MBG with the MBG LAN side 192.168.200.254 hitting the WAN port on the RV325 - 192.168.200.1Th...
