I'm new to this network. They're running iBGP, ospf and MPLS as an enterprise on a regional network. I've done VRFlite with MPBGP before between a CE and PE router, but there's a lot I have to learn about actual MPLS and label switching. There's a...
Hi, Hope you can assist. I have setup a 887VA with a Client VPN but before deploying onsite, I was wandering how to make it more secure. Other than ACLs I see no firewall configuration "Ip Inpect Command Un recognized" The datasheet says its supporte...
Hi this is my first post, We have two separate networks running between several sites, 1) Old Network running ospf2) New Network running BGP in the core They each have they own dedicated links between two of our site, but now we are looking to remo...
Hello i have a configured a trunk port between a Cisco and a DELL powerconnect however i cannot pass traffic the Blue is CISCOthe Orange is DELL What did i mis-configure? Native VLAN is 20 for DATA
Hello There Witch Cisco rugged Series devices have capability to support flowing specs : 1- min 3Gbps and min 0.25MPPS throughput 2- support max 6 x 1G ports ...
Hello Freinds Greeting Does G.8032 used in SDH Ring while BFD used in IP i m a bit confused :( Kindly Clarify thanks Ibrahim
Hello Freinds Has Cisco DIG for DCI based on GTM/LTM as you knew cisco has no SLB/GSS Solution's :( pls Help Thanks Ibrahim
If we running urpf under one interface and config this interface as source interface in one monitor session does traffic get sniffer to wireshark wheather traffic hit URPF or not？
Hi everyone!I have devices enabled with management ports to access. Those are placed in DMZ zone specially like DMZ SW, VM servers, SAN SW etc.Now I have queries need to be answered:1. What will be the best practice to connect to manage them through ...
Hi, Hope you can help. I am installing a 877VA and connecting to 3750 Core and need to access video streams over VPN to 3 internal inter-routed VLANS... VLAN1 = 192.168.153.1\24VLAN2 = 192.168.150.254\24VLAN3 = 192.168.151.254\24 I have my 877 workin...
I have installed Packet Tracer 7.2.1.0404 on macOS 10.14.5 . Whenever i run packet tracer it keep asks me for username and password when in the past when i was using packet tracer on windows system it would ask for login only once after the installat...
Hello. I have a Catalyst L3 switch facing two ISPs using BGP (one ISP as primary and the other as backup), and the keepalive and holdtime are the defaults. I need to reduce this timers (keepalive 20 seconds, holdtime 60 seconds) in order to get a fas...
We have a very strange issue happening where a single address in a subnet will disappear from the network. It is happening at random times to different devices, some in the middle of the night when no one is making any changes. One example is a domai...
Hi- I am having as issue with the spine receiving type-2 routes. The type-2 route for a connected host is present on the Leaf, but not advertised up to spine. Any help is appreciated.!-Leaf nve outputVTEP01# show nve interfaceInterface: nve1, State: ...
Our network uses static routes and VLANs to direct and separate traffic. I do not believe we have a routing protocol enabled. If I enable EIGRP will my network stop working correctly?
