Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

hi,I have two routers that are part of asymtric connection toward exernal partner. Sometimes traffic from one sesion goes over one router and returnes over another and that is fine. I have monitor capture session that captures some traffic and becaus...

Hi all, i have topologi forti(as a router internet &mpls) - Core switch - Palo-Alto ( FW server Farm) Connection core to forti using ip p2p & static default route 0.0.0.0/0 for access internet & access MPLS, Connection core to Palo-Alto using ip p2p ...

Randikdik by Community Member
  • 100 Views
  • 2 replies
  • 0 Helpful votes

Hello,I have in my enterprise many dynamic routing protocols, within VRF and without VRF, like , EIGRP, OSPF, eBGP, ISIS and static routing.Im good with those and dont need to do any kind of upgrade.I have MPLS L2 VPN/MPLS L3 VPN , MPLS TE and IP Rou...

rpalmeida by Level 1
  • 723 Views
  • 8 replies
  • 0 Helpful votes

I hope someone can help me find an answer to this scenario. We have another organization with which we have a site-to-site tunnel. This tunnel is located at our home office. Our remote sites have site-to-site tunnels to the home office. The other org...

I see that the lower ASR100x-X routers are already EOL. For the ASR1006-X and ASR1009-X there are no EOL dates out. Does anybody have any information on the expected lifespan of these components?

mat1458 by Level 1
  • 146 Views
  • 3 replies
  • 0 Helpful votes

I'm curious what the difference is between the following log entries: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/3/0, link down due to remote fault%IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/3/0, link down due to local fault What would...

Hello all,I'm having trouble getting my BGP peers to show up in the VPNv4 BGP peering output.For example, if I have a very simple topology of 2 routers directly connected, and I run simple BGP between them using the IP on the directly connected link ...

vv0bbLeS by Level 3
  • 191 Views
  • 3 replies
  • 0 Helpful votes

Hi I am currently using my SG350XG but am going to move over to my Nexus 9K C93120TX. On my SG, I have these settings for ACL/PBR/vlan8 which works; ip access-list extended SL deny ip 192.168.0.0 0.0.255.255 192.168.0.0 0.0.255.255 permit ip 192.168....

TheGoob by VIP
  • 986 Views
  • 18 replies
  • 1 Helpful votes