SD-WAN and Cloud Networking

Hello, Is there a way to add cellular credentials to the generic bootstrap file?  We have on Prem deployment of sdwan. The full config bootstrap has the cellular creds, but for security we only want a limited bootstrap config file which will only con...

Good day , so I have client that has CISCO SD WAN solution , at his HQ he has 2 cEdges ISR  that are fully working on the fabric , he wants to swap them with 8000 series routers while keeping the connectivity of the HQ as much available as possible.e...

azure express route and internet vpc to two physical N7K, Amazon direct connect and internet vpc to two physical N7KAzure express route and Amazon direct connect use the same logical VPC router with internet.  Will there side channel attack that inte...

I'm working on a SD-WAN lab on EVE-NG vm and I'm trying to access vManage GUI but it keeps saying "this site can't be reached". It worked before but now it just can't. The request nms all status shows that application server is running. I'm working o...

Hi All, I am configuring SD-WAN/SD-Access independent domain pairwise integration. I have configured a port-channel with sub-interfaces per VN on an 8500 cEdge via CLI add-on Template, connecting to a Fusion switch. I am enabling CTS and found the 'C...

Hi All   We have constructed an On-Prem Viptela Lab using Viptela version 18.4 using VMware with ESXi 6.5. I know that as per Cisco Docs the supported versions are 5.5 and 6.0 but have found many blogs where people have tested the Lab without any iss...

Hello, I'd like to get more information about the effect of the 'capability vrf-lite' command on Cisco SD-WAN Edge devices. I'm using IOS-XE Version 17.3.3. I tried some things in the lab to test what happens if the command is there and when it is no...

Hi ,I added a router into pnp site and we tried to synchronised with vManage. All parameters was add to pnp, the vManage when sync, it hears the device, it is present , but when terminated the sync we not see.what do I have do for add the edge router...

HI I am using vManage image 20.6.3 and following all the steps mentioned in how to guide available EVE NG official sitehttps://www.eve-ng.net/index.php/documentation/howtos/howto-add-cisco-viptela-images-set/i am using the following commands for addi...

Hello everybody,out customer has a SD-WAN router:cisco C1111X-8P (1RU) processor with 1971490K/6147K bytes of memoryrunning IOS Version 17.6.3a.Our monitoning generated an alalm for high CPU load.The command 'sh process cpu sorted' shows small values...

vManage 20.3.4.1 POST/dataservice/template/device/cliAPI was successful.We upgraded vManage 20.6.5.5.After update we can see below response from vManage.{"error":{"type":"error","message":"Reserved variable","details":"chassis-number is a reserved va...

We have plenty of vEdge devices in the network; we are starting to convert them to cEdge devices. This is being done remotely. Converting the device to IOS-XE is relatively easy, and the process through vManage works well. It's when that process is d...

I have built a few SDWAN Viptela labs on hardware and software and had a number of issues with creating certificates mainly on the 3 controllers.After having to rebuild a lab again for similar reasons I have run into the same problem. What I have not...