unable to the onboard vedge device and I installed the root CA and activate the chassis number as per the below output.vEdge2# show control local-propertiespersonality vedgesp-organization-name viptela sdwanorganization-name viptela sdwanroot-ca-chai...
Hello everybody,how can i add a vedge to vmanage without using a smart account currently unavailable for private individuals?thank you
Hey,I have Cisco C1117-4P ISR already, use this routers for SD-WAN solutions. Is Cisco 2960X switches or 9200 series switches are compatible with them? I need a located a switch one of our companies locations.I think Cisco make a table for this, whic...
Anyone got any idea about how to use vManage draft mode for templates?
Hello all, We have a need to implement a "legacy" routing solution at a branch office that will transition to SDWAN in the future. Is it possible to use a 8200/8300 (or another device) in this "legacy" routing mode and then reconfigure to SDWAN when ...
I am currently working on a migration to c8200 vEdge devices. The existing routers are utilizing a trunk group on their FXO ports. I have found where to configure my voice line cards to group the FXO ports into a trunk group but I am not able to find...
Hello all , I have 2 Vmanage at different sites, but I can't create active cluster and standby cluster at Vmanage and the vmanage appeared this error ( Check the Pic). Note: each vmanage has 2 ports out-of-band port plus enterprise port under vpn ...
if we have service VPN 10 at Dubai Vedge and service VPN 20 at India Vedge then Can they talk to each other by default?I think VPN is like VRF concept so do we have to keep same VPN ID at both end by default?and one interface is member of one service...
Hi Original devices connection is like this Core switch ---- Firewall ---- internet. We would like to add vEdge router between the Firewall and Internet. That would be relative easier. But second plan is to add the vEdge at between Core switch and Fi...
Hi Company has mpls and internet connections and want to setup SD-WAN from scratch. vManage, vSmart and vBond can be setup via VM at the company's network. and Vpetela need to order. Is this all we need to do? I mean, do we need some vendor? Thank yo...
Hi,I want to know the SNMP OID value for monitoring the status of vEdge power supply.
Hi,I am trying to collect syslog about ZBFW action.I see log section indicates N/A when I select action as inspect.Does this mean I can't collect log?
Hi Team, We onboarded number of devices when our MANO was on following versionsvManage: 20.3.4.1 vBond: 20.3.4 vSmart: 20.3.4 We created number of device templates and everything was running smoth for on-boarding cEdge devices ( on 17.3.3 )Since we u...
Hi vEdge1 and vEdge3 are connected like first below picture. After vIOS1 send extend ping to vIOS3, we got data flow info from vManage like the below second and third picture. We get data flow info from vEdge01 and vEdge02 via vManage as below: Ba...
Unfortunately I cannot find any documentation regarding this design. I am trying to install vManage and vBond in a DMZ with private 10.X.X.X address and do static NAT on the firewall facing Internet. This doesn't seem to be working for vManage. I can...
