Switches - Small Business

I have a SG300-10Mp with 8 WAP attached, the switch is behind a router and two additional switches. I all comes up and I get wireless Internet at all WAP, but all of a sudden it stops working, the Internet is not longer accessible and its connected t...

Hi all,I have a problem to get lldp to work.My setup is as follows:Router (with lldp support) <----> Linksys SRW2008 <----> Workstation (with lldp support)Querying lldp neighbors from my router show up only its own interfaces:vyatta@vyt-node01:~$ sho...

Hello All,One of our SRW248G4P's is making a lot more noise than usual.If I put my ear to it there is a "grinding" noise inside.I think a fan is about to give up.How do I open this switch to check the fan(s)?I could not find anything in the manual th...

SG102-24 24 port unmanaged gigaswitch18 computers and one internet modemfollowed direction basically mount connect computers turn onI did this last night as office was empty. I hab an internet connection before I got back to my deskMorning no one els...

Hi all,at the moment we have trouble with the following SRW208 setup:- Port mirroring is enabled (Port 8 mirrors Port 1) for sniffing via Wireshark in promiscuous mode.- 'IGMP Snooping' is enabled for all ports.Our test scenario:- an IPTV settop-box ...

I am replaceing our 3560 Switch with a smaller 300 Series switch. The current access ports on the 3560 switch are configured for spanning-tree portfast and spanning-tree bpduguard enable. Can someone tell me how I can set this up on the new SG300-10 ...

I have a Linksys switch model SRW248G4P that is not booting. After connecting to the console, booting process stops imediately after loading the diagnostic image file. Is this switch toast? Anyone knows what is the warranty on this type of switch?

Hi, By recommendations of a person in cisco support chat I've uploaded SRW2016 firmware to the switch via tftp whithout uploading first the bootloader. When the switch restarted, I was unable to get a connection by ip address. So I connected the swit...

Hi guys,i have one SRW2024P connected through fiber to SRW2048. I would like to create isolated link between these two switches consisting of at least one isolated port at each switch. Can this SRWs do this?Alternatively i need on the SRW2048 side fe...

device is SRW224g4p-k9.   I need to provide DHCP parms for two VLANs.  I can not find any reference as to how to do this.  A $400 Layer2/3 managed switch must support acting as a DHCP server, or am I missing something?

Is there a way to reset this back to factory defaults when you cannot login ?

Is there any function in SR224 smart switch similar to Protected Port function in SF300 ?  I need port isolation at the switch level.  VLAN isn't feasible because multiple SR224's would require a costly router capable of 100 VLANs.  Protected ports i...

Hi,On a small LAN built with 3 cascaded srw224g4p (through the GbE ports) there will be a number of VoIP devices with known IP addresses. I need to guarantee minimum latency to those devices.The setup I have thought is:- Define one ACL (Action: Permi...