Switches - Small Business

Good evening everyone,  I have had the misfortune to have never run into a SF300-48 before recently. It is a doozy of a CLI and GUI. I can't seem to get my ShoreTel phones and LAN working simultaneously and the configuration of this device is counte...

Hello, I have a SG200 switch configured with 2 VLANs - VLAN 1: The standard VLAN on the switch (172.10.100.0/255.255.255.0).   Let's assume the client is connected to Port 5 on the switch. - VLAN 20: The VLAN id for wireless (172.10.200.0/255.255.255...

Does anyone know if there's a way to reset the SC 100D 8 port switch?  My issue is that while this is a gigabit switch, I can not get over 100mbs on a speedtest for my network. As far as I can tell, there is no software or firmware that's upgradable ...

Hi i have a scenario where i am trying to add an Ip address to a physical port on small business switch i have already made it layer three but cant cant add an ip on the sfp port please help. sfp port is GE3 or GE4

Hello Team, SG350XG-24T-K9-EU has 24x 10 Gigabit Ethernet 10GBase-T copper port. Are all of these ports 10/100/1000/10000 or only 10GE? Thanks, Nenad

I have erased the flash and reloaded the firmware onto a 24port Linksys SRW224p switch The only problem I now have is the mac address is 00-00-00-00-00-00 which is obviously going to cause problems. I have the previous mac as it said please remembe...

Can I stacking SG500X-24 and SG500X-24P and SG500X-48 in one physical stack?

i did setup for gvrp in my two sf 300 switch: I enabled GVRP on the TRUNK ports  for all switches  I allowed all vlans on the TRUNK ports  I  enabled the GVRP globally i follow the instruction and applied in first and second switch,  but still i can...

Hi  I'm trying to upgrade the firmware to 1.4.7. But i get an 'illegal software format while trying to upgrade' error. After searching around i find i have to update the bootloader to 1.3.7.18 (the highest in the 1.3 serie). But the download Cisco se...

Hello, I'm trying to solve a strange behaviour of my Smart Switch Gigabit SG 200-08. After 3 years of flawless use, ports no.1 and 2 suddenly went off. Front LEDs are off, and the port configuration webpage shows them labelled as "Inactive connectio...

Hi all possibly a simple question. I have 5 SG500 switches. 4 are currently configured as a Stack and in production. 1 is spare and that i use for test. On the spare one, I have configured vlans, and interfaces and all the settings the way i would ...

Attempting to create routed port between a pair of SG500x. Show run shows: set system queues-mode 4 GUI System Operation Mode: L3 and L2 mode Interface has IP address assigned. When I enter the no switchport command get incomplete command.  Options ...

Hi Team, Am doing a POC with FindIT Probe at customer place. Together with it, I have RV320 router and SG500 switch too. I was able to get a topology view on the RV320 and SG500. I have some questions. 1) I was not able to get meaningful representati...

Internet works fine when Ethernet connected directly to computer.  but when connected to switch, then routed to computer it will not connect to internet, just says unidentified network.