Switches - Small Business

I have an SG300 28P with a default vlan1.  It is on the 192.168.1.x network.  I want to have three ports assigned to vlan 2 and place allow those ports to accept traffic from the firewall for 192.168.2.x network.  Can someone help with steps to make ...

We've just added some of the SG302 switches to an existing network of (mostly) 2950 switches - to provide some PoE ports for wireless APs.After configuring MSTP identically to that on the existing network, it looks like the SG302 switches can't handl...

Hi,I currently have 2 VLANS setup on 2 Cisco SG500 switches and I am trying to pass both VLANs traffic over my trunk. My setup includes the following:Switch 1VLAN 5 ports 1-32VLAN 8 ports 33-48Trunk port 50Switch 2VLAN 5 ports 1-32VLAN 8 ports 33-48T...

Hi,Can I configure the 10GE uplink interface of the SG500X as switcport access?Partner is asking if a server with 10GE interface can be connected to the 10GE uplink of the SG500X.Mark J.

Hello!Recently I have installed near a hundred of SF-300 with the latest 1.3.0.62 firmware and the simple config: opt82 with arp inspection for access ports, rstp, management vlan. SSH and HTTP are disabled. Management IP addresses are statically ass...

Easy test: take an SG200-08 with firmware 1.0.7.4.  Reset it to factory defaults.Connect two computers.  Suppose that one of them is 192.168.1.2.  From the other one, do:$ ping -s 1472 192.168.1.2This works fine.  Now do:$ ping -s 1473 192.168.1.2Thi...

My SF-200-48's had the aging box checked and I hadn't realized it. Now I've attempted to reset the password and even if I copy (from notepad) or type it in carefully I get the error Incorrect Old Password. Mind you this error shows up right after I j...

I am not able to contact the switch. The system light is blinking continuously.Probably the device is out of warranty. Is there some kind of procedure that you can try?

Hi  Is it possible to order Cisco SMB switches (100/200/220 series Switches) from every region? We are in Sri Lanka (Global Asia-Pac Price List). In CCW I am not able configure most of above series switches. On 100 series switches I can configure bel...

Good day.I connect to switch Access Point, configure port on switch which vlan work on this port. But after reboot AP my config for this port delete and have other config where vlan 1 untagged, and allow all other vlan. But in my cinfig allow 3vlan: ...

I have upgraded to FW 1.3.5.58 about 2 months ago.  Everything seems to be working as expected.  Just recently, I noticed that If I rebooted one of my IP phones that is powerd from the switch, no DHCP lease.  I currently have this connected to a Cisc...