Switches - Small Business

Hello all,I am looking for a low-cost managed switch to replace the 2960's we have. This is for remote office locations. The following ciriteria should be met:1. CLI interface that supports SSH or Telnet. Switches with menu driven interface can't be ...

Will the cisco sf-300-24p be able to do vtp?  Ineed to connect it to a cisco 3560G, It would be nice if it get all the info it needs from VTP.If not does anyone know how to work around this limit?Also any idea when the next firmware release is going ...

Hi!I'm trying to set up MAC and IP based ACl on our switches with no success.Port 22 is our wan porti'm trying to stop ip 192.168.0.53 reaching internet.but i need to let all other traffic to pass.with ip rule with Deny 192.168.0.53 wild card mask 0....

how many concurrent voice call can be conducted at once with the cisco sf 100d-08 8-port 10\100 switch?

I have a SG 300-20 small business switch and I would like to restrict bandwidth by gateway ip address but not by physical port or LAG. On the web interface, I can only do bw limiting per port or lag. I want to do bandwidth limiting by the IP addresse...

Hi everyone,Just got a new SGE2010P layer 3 switch. I'm trying to configure Vlan to reach a few subnet. I have the original 192.168.1.0/24 as vlan1. I want to reach our WiFi subnet 192.168.10.0/24. The WIFI router is directly connected.  It's new for...

I just received a Cisco model SG200-08 switch.  The A/C power adapter label claims that it will take 110VAC or 208VAC, but it has a typical 110VAC plug.  I want to power it from my UPS protected rack which has 208 power distribution units.  Is there ...

We recently purchased a SF 302-08P to replace a old 3550 switch.  Is it possible to setup the ports for phone and data?  We have a voice vlan and data vlan.  I can get the phone to work however if I daisy chain the computer off of the phone it will p...

I'm quite new to the cisco managed switches. we have a customer who is wanting to integrate a VOIP solution into their existing network. They have cisco sg-300-28 switches at their offices. From what I understand this VOIP solution doesn;t use IP pho...

Hello, recently we bought 2 SG200 to expand our network to Gigabit.We own 1 Catalyst 3650.We tryed to Etherchannel between the Catalyst and one SG200 but with no luck.At Catalyst i created the port channelinterface Port-channel1 switchport mode acces...

Have an SRW2024 that I was updating firmware and it got interrupted. Now I can't access the switch from either console or IP. Switch will not pass traffic. Is there a way to get this switch completely reset so I reconfigure and use it again? Thanks.

Hello everyone, I have a question, does the SG300-28 support VTP and STP?. I want to add it to my network's VTP domain so I don't have to manage vlans manually on the SG300-28 and also be able to configure STP to keep my network loop free.Thanks.