Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

After the restart of a 3650 distribution switch stack that is acting as an RP, a downstream switch was not able to send multicast traffic; other parts of the network were not affected. After considerable troubleshooting, we discovered that removing t...

Hello, should I be concerned with the following output during boot of a switch stack? I'm concerned about the message..Image failed digital signature verificationError loading "flash:/update/c2960x-universalk9-mz.152-4.E8/c2960x-universalk9-m z.152-4...

hmc250000 by Level 1
  • 5168 Views
  • 14 replies
  • 0 Helpful votes

I ask this question due to the Cisco announcement made at https://www.cisco.com/c/en/us/support/docs/security-vpn/public-key-infrastructure-pki/215118-ios-self-signed-certificate-expiration-o.html#anc15 and am currently looking and trying out differe...

4kali by Level 1
  • 1398 Views
  • 1 replies
  • 0 Helpful votes

Hello, I'm trying to configure a Cisco 3850 with Fios.  I'm able ping across platforms and can ping all vlans.   I can't connect to the internet when I connects clients to any of the vlans.  Here's what I have on the switch: (192.168.1.1 is the Fios ...

smutnpj10 by Level 1
  • 1367 Views
  • 1 replies
  • 0 Helpful votes

I need to select 6 new switches, and the model that fits my requirement in terms of ports is "C9500-40X".I also need to implement Stack technology on them but according to the datasheet the StackWise Virtual is not supported yet on "C9500-40X" model....

bledi_vako by Level 1
  • 34726 Views
  • 30 replies
  • 3 Helpful votes

Hi everyone, I need explain about config SLV on C9600:1. When SVL group links down, By DAD link, act switch convert to Act Switch-Recoverry mode, Stanby Sw- active. But SVL up why act sw-recoverry mode cannot switch back to the original. 2. As Cisco ...

Hello ; I have a 3750G switch that it has flash not detected on Roman mode, I try flash_init and dir flash: but no look as below :switch: flash_initInitializing Flash......The flash is already initialized.switch: dirList of filesystems currently regi...

youness10 by Level 1
  • 3696 Views
  • 9 replies
  • 0 Helpful votes

For a learning purpose I am creating a VLAN using an old switch: catalyst c2950. I used the suggested commands found on this community below :  Switch(config)#vlan 10 Switch(config-vlan)#name Restricted LAN Switch(config-vlan)#exit Switch(config)#int...

ma-si by Level 1
  • 2045 Views
  • 11 replies
  • 0 Helpful votes

we have collocation DC where customer can connect external switches not under our control, our aim is to protect our network from any changes done on the external switches cloud lead to L2 loop, we want to stop customers from participating in our STP...

eagle. by Level 1
  • 581 Views
  • 1 replies
  • 0 Helpful votes

Hi, we use two SG350XG-24F as a Stack as core switches and 3 SG350XG-48T as access switches.The stack members are connected on fiber ports 23 and 24.  Each access switch is connected via DAC to each stack member. No LAG there.We only created a LAG on...

IFM by Level 1
  • 3955 Views
  • 14 replies
  • 0 Helpful votes