Switching

I had the unpleasant experience of getting a piece of paper stuck one of in the fans today. The fan has been making a weird noise ever since. I called TAC and treated it like a LVL 1 case because prior to that, I had no idea if the fan was hot swappa...

Is it possible when I enable NX-API on my 9Ks to access them via a specific L3 vlan. The reason is we don't have our mgmt0 interfaces configured.   Thanks

Hello all     I have a situation that I am unable to understand. We have two Nexus 9K's connected across two different sites via two 10GB fiber links. Both ports are part of the same port-channel. However the other day we were getting log messages in...

Hi everyone. Im studing ccent and im not very confident about the up/down information the book gives so i need to clarify my mind.Where are u supposed to get an up/down state on an interface? Ive been trying things to see if i can get it but everythi...

Hi,   We plan to upgrade the IOS of a 7609-S router with following hardware -   SIP200 SIP400 W6748-GE-TX with DFC3B SUP720-3BXL SSC-400 Flash - 512 MB DRAM - 1 GB   Current IOS - 12.2(33)SRE2 Planned IOS - 15.3(3)S6   My queries are as follows -  1....

Hi everyone. I need your help on one issue about rate-limiting. I work in service provider company and we have WS-C6506-E Catalyst which is connected to another ISP and is working mainly for internet service. However there is a problem with rate poli...

I have a customer, who is facing a strange problem. His current scenario has a couple of Cisco 4500-X core switches (running in VSS) that are connected to some SG-200, old 3com (manageable) and unmanageable access switches. He is running PVST with on...

Hi Everyone,   I have a 4510 switch with dual redundant supervisor "WS-X4516-10GE Supervisor Engine V-10GE"    I need to provide two 10G Uplinks to 2960 switch having 10G SFP Module and i need two 10G copper uplinks to some servers. the supervisor ha...

Hello ,I have an old cisco 1800 runing VPDN configuration and I change it to a new ISR4000.All the current configuration works including the VPDN , users dialup , request is forwared to the local radius server . they are approved by the radius and ge...

Hello, I have a route-map as below. The purpose is to direct certain traffic out towards a secondary internet exit point router e.g. 10.99.1.1. The problem is that the next-hop of this route map (192.168.2.5) is not far away enough to get traffic to ...

We are currently specking (33) Crestron DM-NVX-350 and each one requires (1) gigabit to endcode/decode   Does the C3650 have a backplane to support 33gig?