Switching

Because of administrative distance will a static default route replace an external EIGRP advertised route?  We are getting an advertised external EIGRP route coming in from our ISP's edge router located in our building, what I'm asking is, can we ent...

So I have this issue that affects only my 3750G switches and they are using 15.0(2)SE9 IP Base. Routing looks good all the way to the NPS server and every other device on the same subnet can communicate to NPS just fine and packet captures from the f...

Hello, Issue: Currently, the inbound/outbound calls are dropping. We have a Voice2800 Cisco Router:    Cisco 2821 (revision 1.0) with 249856K/12288K bytes of memory.   2 Gigabit Ethernet interfaces   24 Serial interfaces   1 Channelized T1/PRI port  ...

would like to pass traffic to ASA first before inter vlan routing at 2901 router because I would like to control vlan 2 can access vlan 3 but not allow vlan 3 to access vlan 2 2960 vlan 2 switch 1 ---> 2960 switch 0 ---> ASA ---> 2901 router 0 --> 2...

Hi ! I'm trying to authenticate from Solwarwinds application to our Nexus 5596 switch.  I'm always getting the following error message : 2017 Jun  2 14:35:35 SWITCH_HOSTNAME %AUTHPRIV-3-SYSTEM_MSG: pam_aaa:Authentication failed from Solarwinds_IP -...

Hi, I am working on a customer quote required 100+ Catalyst 2960 switches and 30+ ISR Routers and Prime Infrastructure to monitor them. I am actually confused about the license tokens of PI required for the devices. I have used C1-CISCO4321/K9 for th...

hi every1, plz some 1 solve this problemsuppose i have 10 contigiuous networks connected on my routers loopback interfaces10.1.0.1/1610.2.0.1/1610.3.0.1/1610.4.0.1/1610.5.0.1/1610.6.0.1/1610.7.0.1/1610.8.0.1/1610.9.0.1/1610.10.0.1/16now i want to adv...

Hello all, We have two networks which is connected to each other by leased line, one network is our data center and other is our Branch location. we have configured multicasting in dense mode on both the end over all the interfaces. we are able to pi...

Hello, In VSS documentation, we can see that there are few events affecting the "catalyst 6500 CPU" (Sup2T MSFC CPU) that could cause the loss (or the flapping) of the VSL link: " • High CPU utilization can trigger a VSLP hello hold-timer timeout, wh...

Hi My network is a star topology and has 3 multilayer switches, model 3650, interconnected to each other with each of them has their own Layer 2 switches connected. At first, I've set up trunking on all of the them, both Layer 2 and Layer 3 switches...

Hi If my Nexus switches, says is missing this: ENHANCED_LAYER2_PKG           No    -   In use             Grace 83D 3H This is the license to buy right?  L-N5548-EL2-SAK9=  (My Nexus switches is Nexus55489Up). Regards Kenneth Dalbjerg