Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

My SG 200-08P can't access the web-interface. the problem is without plug the WLAN to switch the LED light is solid green, so I suspect the switch has been setting an static IP address on it. I check the CISCO manual for the SG200-08P don't have rese...

wenchunx by Level 1
  • 370 Views
  • 2 replies
  • 0 Helpful votes

Hi, I'm not well versed in VLAN networking so I have a very simple question (I hope).  Unfortunately my Google skills are letting me down as well; so I'm hoping that one of the learned people on this forum can spare a few moments to assist me. I have...

bluepill by Level 1
  • 2381 Views
  • 7 replies
  • 0 Helpful votes

We purchased a couple Nexus 5596T Switches that came with older firmware on them: n5000-uk9.5.2.1.N1.4.bin and n5000-uk9-kickstart.5.2.1.N1.4.bin I would like to update the firmware before putting them into production.  I notice there is version 5, ...

NPT_2 by Level 2
  • 899 Views
  • 3 replies
  • 0 Helpful votes

Guys,Anyonen know of a tool for windows or linux to set IP packets with certain ToS values. ping -v under windows does not seem to work?Rather than loggin onto the routers and running extended pings?Many thx indeed,Ken

This is an old Cat 3560-48PS switch. There are two SM modules in this switch; only one is being used. Gi0/1 is the one in use. Am I about to have this port fail?                                  Optical   Optical            Temperature  Voltage  Tx P...

I'm having issues running BFD between a Cisco 6509-E and a F5 Load-balancer. dsr01#sh verCisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9-M), Version 15.1(2)SY, RELEASE SOFTWARE (fc4) F5 running 12.1.2 ZebOS version 7.10.6 IPIRoute...