Switching

    In this project there are two switch 6509-V-E with following configuration: Slot Part number Serial number Switch Number Firmware (Mod mac add) HW (Mod mac add) HW (sub module) Switch IOS 1 WS-X6848-SFP SW-1 (Active) 12.2(18r)S1 ...

Hi all, I have a L3 switch (3850) with a Fa0 Ethernet management port configured. int fa0 - ip address 192.168.10.6 255.255.255.0 The L3 switch has ip routing turn on and hence in show ip route we can see      192.168.10.0/24 is variably subnetted...

HostA<PC>-------------Switch<L2>--------------RouterA<---------------------->RouterB---------------------------Switch<L2>---------------HostB<PC> In this above scenario, while we ping HostB from HostA the ARP packet goes all the way from host A to h...

what is the difference between watch-timeout and finrst-timeout when tcp intercept in watch mode both are send rst to cut connection, what is the difference? if i do not sest finrst timeout , will it terminate normal connection after default timeout ...

how to set connection-timeout of tcp intercept in router to infinity or never cut established connection for watch mode default it cut established connection in 24 hours but i hope it do not interrupt normal conection forever if some application are ...

Dear all, I hope to find some help or hints in this matter. We are running two compute clusters, each having a separate stack configured. In site A, we have 3x C2960S (f/w 12.2) in a stack, in site B we have 6x C2960X (f/w 15.2) in a stack. The comp...

Hello, I need some advice and, if possible, links to resources i can use to implement this. Thanks in advance I want to create a hotspot for a network i manage at a hotel, such that all checked-in hotel guests can login with a room number and a syste...

Hello, I have a question concerning the connection of my 2950g switch to my wireless router. I have a (zoom 5352) type of router that I bought myself for my internet access, and I have comcast as my ISP. Everything in my network works fine, all the d...

Hello Folks, I faced recently an issue where there is a vlan 40 with ip address 172.16.0.0/23 and int vlan 40 is 172.16.1.1/23.There is also a firewall with ip 172.16.1.2/"24" int the same vlan. There are users and some test servers also in the same...

we have three router R0, R1, R2 connect together, R0 and R1 both use G0/0, R2 and R3 both use G0/1. all the interface are up, but we can't ping the neighbor although EIGRP is activiated. Ro config: Router#show run Building configuration... Current ...

I have a 2950, the ISP we use gives us a Cat 5 cable with RJ45 connection.I put it into a very basic configured 2950 and I cannot get to the internet.I have a PIX 515E and RV320 that connect into this 2950.They can talk to each other and build VPN Tu...