Switching

I am simply looking for a command to find out which dhcp pools are applied. I have quite a few reserved addresses on my network, so it would be very useful to find out what is applied where.

Hai Is it possible to connect GLC SX MM 1G  to a core with X2 10 G SR . ALSO SFP 10 G SR to X2 10 G SRConsider all multi mode. Thanks     

Hi, we have these commands configured in a 6500 but we dont understand what these commands do, and it shows a warning if i try to delete them (cos-map) interface GigabitEthernet1/18 description ENLACE switchport switchport trunk encapsulation dot1q s...

Hello, I am doing a VTP configuration review on a site with 8 switches. All switches are in server modeThe domain and password is the same for all switchesPruning is disabled across all switches Questions: If the main benefit of VTP is less manual ad...

Can we configure HSRP for LAN core high availability on the Cisco WS-C4507RE-S7L-96 (Primary switch with universal crypto image) & Cisco WS-C4506E-S7L-96 (secondary switch with universal image).

Hello,I have a 891 router with FastEthernet0 - 7 being layer 2 and FastEthernet8 & GigabitEthernet0 being layer 3. Is it feasible to configure sub-interfaces or router on a stick on any of the L2 interfaces? If so what's the commands to achieve this?

Hello, I am struggling to my surprise at what I thought was going to be quite simple so... here I am. Thanks in advance :) I have two Cisco routers on each end of the building and one is a 3825 and one is 2851 each of these routers has their own swit...

Hi!I'm need a Packet Tracer file, include this:1 server, 2 'rooms' (5-5 computers in rooms).The server can communicate with computers, but computers can't communicate with the computers from other room.IP:Server: 192.168.3.200Room 1: Static, 192.168....