Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi ,I have  Cisco ASA 5510 series router  which was handling by our one of  our network admin who left without giving admin password. Now this is time to  break the password . Since i don't know  the admin password of the router , i don't how to hand...

I am trying to connect my Access Server to my main network via the AUI port and I am not able to ping any device... could help please?Current Config:Access_Server#show runBuilding configuration...Current configuration : 1113 bytes!version 12.3service...

jwood1650 by Level 1
  • 4141 Views
  • 14 replies
  • 0 Helpful votes

I have spanning tree set up on Switch -1 for my management vlan which is the root (Mgmt vlan is on all switches). I have 4 switches that do have the management vlan on them in addition to a SAN VLAN.   Switch 1 does not have the SAN VLAN active. Is i...

I've read that certain 6500 modules have restrictions with regards to total throughput because of the 1gb port ASIC.  Do any of these limitations exist on the 3750/3560 switches?  That is, if I create an 8gb channel can I expect 8bg throughput?Thanks...

SpongeRob by Level 1
  • 827 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Local Login

I am running a C3750E switch and I am just practicing, but I cant get login local to work on the VTY lines or Console line. I have a local account with a password. I type the following:username new view NEW secret cisco(the NEW is the Parser view Im ...

I am looking to configure a switch to support PXE, it works straight by adding ip-helper statements in normal scenario when DHCP service is running on box other than the switch having SVIs configured. However in a special case, I am trying to configu...

Hi,I am trying to limit the bw of a gre tunnel to 60Mbps and any packets exceed this rate drop them. Problem it seems is you cannot apply a Service-policy output <word> to logical interfaces. So below seems to be the only option:vlan configuraiton 93...

Hi,It's generic question about the Energy-efficient Ethernet facility.I'm wondering if the LPI mode activation is well fully unidirectional.For a single port in a equipement (linked normally to another equipment) is it possible to activate LPI mode i...

hostettle by Level 1
  • 602 Views
  • 0 replies
  • 0 Helpful votes