Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Resolved! 2801 router error

I was in ROM mode on my router, trying to perform a password reset on my router, and now it only shows jibberish to the console when I boot the router. e.g. €žøž†ž þ þàžø æfþþþþž þ`þ˜øø€ž`þ`þþ˜øþ†þ†~þ~þ~þø† þ†ž þ þþžø† þþžæžþ†`þfþ þ€ž þfþþþþž þ`þ怘€...

I am getting this error from Nexus 7K. What could it be? 2012 Feb 21 15:17:14 NX1-DataCenter %ETHPORT-5-IF_DOWN_ADMIN_DOWN: Interface Ethernet10/46 is down (Administratively down)2012 Feb 21 15:17:17 NX1-DataCenter %ETHPORT-5-IF_ADMIN_UP: Interface E...

Hi all,NDA-AF4S04#sh mac address-table | include 5b00  1    6892.3429.5b00    DYNAMIC     Fa0/4   3    6892.3429.5b00    DYNAMIC     Fa0/4  12    6892.3429.5b00    DYNAMIC     Fa0/4  97    6892.3429.5b00    DYNAMIC     Fa0/4  98    6892.3429.5b00   ...

Hello, friends.I have recently noticed this when I issue the "sh ip nat trans" command:Pro Inside global         Inside local          Outside local         Outside globalicmp my_public_ip:14743   my_public_ip:14743    69.63.179.125:14743   69.63.179...

I want to configure a single bridge to implement QOS for the videoconference and telephony.No routing ip.  Only a transparent bridge.  This is my config.  Do you know what is the problem ?Current configuration:!version 12.0service timestamps debug up...

simquest2 by Level 1
  • 1081 Views
  • 2 replies
  • 0 Helpful votes

Is it worth implementing IP SLAs to track WAN interfaces in this scenario? I want to load-balance, host-dependent, when all WAN interfaces are up. When all three WAN interfaces go down, I want to switch the ACTIVE GLBP Router to BLUE-MPLS-CE. I plan ...

Hi there,I'm wondering if there are commands in OSPF, other than looking at the ospf config, to;A) view what networks/ subnets/ prefixes My Router is advertising outandB) view what networks/ subnets/ prefixes are being advertised into My Router.I bas...

I have a 3560X that is directly connected to an ASA 5505.  I am seeing output drops on the 3560X interface that connects to the ASA.  Below are the troubleshooting commands I have ran, but I don't see any indication to what is causing the problem.356...

conleya by Level 1
  • 1718 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card