Switching

Hi all,I have two internet link connected to same router. I would like to do PBR in our router . Email via ISP 1 and http via ISP 2. But here i need failover over fauction too. In the event of any of ISP link is down, the specified PBR policy must us...

I am facing problem with one 8 port switch ..when ever I am connecting with this switch 3-4 PCs after some time its showing error disable port. I already checked with another port with same PCs. Its happening the same thing. I tried with different sw...

All,Can you please help with the following We plan to implement multicasting on our network where the sourec and destination are going to be in different vlans.I have a test 3750 switch, Layer two multicast works fine, when I place the source and des...

Hello everyone,I am currently testing VTP version 3, as we need to propagate Private VLAN information between switches.However, it seems that VTP pruning is not compatible with Private VLANs :- When I type "vtp pruning", I get the message "Private VL...

Hi,We are getting continuous high cpu spikes while we are checking in Show Cpu History.7877696987799868787898889899899988999999998999978799689879999998988988    8287546933471147759488242667705722847693587263081432870793575134890331100        *   *   ...

I have Issue with Polycom SoundPoint IP 335 Phones connected to Cisco 4507 switch. I can make the calls but While connected to call, experiencing pause for 1-2 seconds, every 90 Seconds. Call is not getting dropped. Its just a pause fo 1-2 secs. Conf...

HI allcan you please look in to my config and say the natting is correct.int gi 0/0ip address 10.10.45.1 255.255.255.0ip nat insideint  gi 0/1ip address 99.89.99.99 255.255.255.248ip nat outsideint gi 0/2ip address 101.100.188.130 255.255.255.248ip n...

The Default Native VLAN is 1 in Cisco Switches. How can we change it to other  than 1 .? Any Help........

Hi All, I have network configuratios as shown in diagram, i am trying to ping from users vlan 102 to vlan 21, issue is; i can ping some ip's from vlan 102 to vlan 21 and some can not, i had check and verify the configurations everything looks ok. lik...

Hi,   i have a question regarding route summarization. so here it isThe networks connected to router R2 have been summarized as a 192.168.176.0 / 21 route and sent to R1.  Which two packet dstination addresses will R1 forward to R2 ?1. 192.168.194.16...

hi all,I have a serious problem with nexus 7018, there're unicast flooding on one n7k, named n7k-1, which is the member of vPC domain combined with 2 N7Ks.And I think I've already got the reason why this happened. ///////////////////////////That is, ...

In a given scenario , in a single switch if we enable STP cna we co enable Multiple STP like PVSTP or PVSTP+ . ANy comments ?

Dears,I want to load balance between two webservers using ACE10 working in bridging mode, but when putting the VIP in the url i'm getting page not found, tried many configurations but didn't work, here is the latest onelogging enablelogging buffered ...