Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

We have run into an issue between a couple of N7Ks in a vPC topology. We have the N7Ks set up with the "vpc peer-gateway" and we have several SVI's between them running HSRP. The issue is that we have a situation in which 4 of the SVIs on the one N7K...

Hey all,Problem: I have a Cisco RV082, set up as shown in the attached network overview. It continually restarts, lasting only 25 minutes (maybe a stretch to 30) before restarting. Before I get office space on it, might someone be able to share their...

iandlyons by Level 1
  • 674 Views
  • 1 replies
  • 0 Helpful votes

Hi Cisco Support CommunityWe are looking to expand our network.Scenario = 2 floor building, we currently occupy upstairs use a new 881W for all connectivity including Wifi. LAN connectivity is through a 24 port Netgear Switch. On ground floor we hope...

HiI am trying to configure 13 etherchannels on WS-2960s-48TD-L but it has a limitation of 6 etherchannels. The IOS is12.2(55)SE2. Is the number of etherchannel depend on the hardware or software? If I upgrade to the latest version of IOS will I get m...

joe.ho by Level 1
  • 1517 Views
  • 3 replies
  • 0 Helpful votes

HiI have installed the above mentioned card in the router 2800.When i run the command show ip int brief it will display as serial interface.My concern is when i connect a host on that interface it Network icon is displaying cross.I have already ran n...

I'm going to be working on some "older" switches configured elsewhere and have a few questions. For example, this configuration detail on IOS Software, C3750 Software (C3750-IPBASE-M), Version 12.2(25)SEB4interface GigabitEthernet1/0/23switchport tru...

lcaruso by Level 6
  • 1764 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Traceroute latency

It takes 1 minute and 50 seconds to complete a "traceroute" from my branch to company headquarters.  Users have been complaining about slow connection, just thought they were whinning. "tracert" from desktop computer response was normal, so i pressed...

Hi folks,I have a 6509 that had two different modules powercycle themselves about 18 hours apart. It could be coincidence, but I've never had it happen before so I suspect it's related. Unfortunately I haven't had any luck so far identifying a root c...

Hi,I have installed a new cisco2901 router and configured the line vty 0 4 and console 0 and enable secret.But unfortunately I exit from the configuration and while going to login in again.  I cannot login with username and password which is configur...

goutam_04 by Level 1
  • 16192 Views
  • 17 replies
  • 0 Helpful votes

Hi All,I'm trying to connect a Cat3560 SFP (GLC-SX-MM) across MM fiber to a Trendnet TFC-2000MSC Gigabit fiber transceiver.  I never see the interface on my switch come up in a connected state.  I have confirmed that the hardware is good and the fibe...

rkallas by Level 1
  • 1173 Views
  • 2 replies
  • 0 Helpful votes