Switching

Does anyone have a sample config for 802.1X on a 3750 using radius?

Hi to everyone,I am looking for a router solutions for my company and I have thought in this router Cisco 2811 for my company connections LAN either WAN.I have two questions and doubts about this router.First of them,Would be possible to connect two ...

Hi all,I am having some issue with doing policing on Layer 3 SVI.This is my configuration  Policy Map INGRESS-400M    Class class-default      police 400000000 bps 50000000 byte conform-action transmit exceed-action drop  Policy Map EGRESS-400M     C...

Can two VTP Servers exist in a the same VTP domain?

hi all, If I have one link to say an edge a switch which is currently the root switch, If I plug another switch in the root with a lower priority. will the port on the edge switch go into blocking mode once it hears the new bpdu ? if so why is this e...

Hi All,I am here 3rd time for same problem.I have 2 site one is IPPL(core switch) and  2nd one is IPGCL(working on  ring tropology ) .IPGCL is connect to IPPL by trunk port. Under IPGCL i have 16 L2 switch that are used ring tropology with IPGCL. now...

Hello, I am facing a problem in my Singapore office network that a single website is taking 2-3 minute to load the page however other sites are opening very quickly. Proxy server is there in between and users accesing site through proxy. I tried acce...

Hi I have two access switches both are connected to my core Switches. Access Switch -1 is trunk via UTP cable and Access SW-2 is trunk via Fiber. Monitor session command is working with my Access Switch-1.  But whenever I am putting monitor session c...

i can ping broadcast ip in a vlan from any machine that can stuck my network. what are the ways to deny this ip and what are the effect we can face after denying this

Hi Experts,A client is migrating his servers to another segment connected on the same router to isolate those servers from user PCs. The migration would cause a change in ip addressing of the servers however the problem is that some of the softwares ...

Hi Folks,We are doing a security audit and want to disable un used services, there was an old command to disable bootp "no ip bootp server". Is bootp enabled on 3750 by default, is "ip dhcp bootp ignore" will disable the clients connected to the 3750...

Hello,I have issue where Cisco Network Assistant 5.5 is showing Packets with Errors on some Gigabit Interfaces on a 3750 switch stack. Yet, when you telnet into the 3750 and do show interface, show mls qos statistics, show mls qos interface..., etc n...

I have several 2960/2640 switches with "ip default-gateway" configured.  However, the IP of the default gateway recently changed, and the old gateway IP is no longer active.  But these 2960's still try to send *some* outbound traffic using the old ga...

Hello Everyone,I have a customer who has ACE10 modules running in Active/Standby mode in two separate 6500s. The customer wishes to upgrade from 4G to 8G throughput, and add 20 Virtual Contexts. Is it possible to Upgrade just the Active one, and in c...