Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

Hi,I have a problem with spaning tree I have two switches acting as the root bridge for the same vlan the show version of both switches are down below Do I hit any known software bugs,thanks and best regards

karim7784 by Level 1
  • 521 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Whatsnew Command

Hello All,I come to now a new command that "whatsnew" which helps to know what recent changes made on device. i tried on our one of device but did find the command in help. than i tried to find this in Command Lookup Tool but i did not find such comm...

Dear Experts,I have new Cisco 3750E Switch with c3750e-universalk9-mz.122-50.SE2.bin IOS image. Now i m unable to run OSPF. It say OSPF is not supported. Now How can i Upgrade my image to IP Services in place of Universal.....Is there any other way a...

hi guys,I need your advice:I have a couple of cisco 3560 switches and a server with two nics.Which is the best way to get high availabilty? Setting up an etherchannel between the two 3560 and connecting the nics of the server to each port of the ethe...

uosambela by Level 1
  • 1974 Views
  • 6 replies
  • 0 Helpful votes

R1 is the first hop router. fa0/1 is directly connected to R2's fa0/1R1's int lo0 is the broadcast sender to destination port 12345.R2 is the last hop router, fa0/1 is directly connected to R1's fa0/1. R2's int lo0 is the broadcast receiver.Conversio...

Hello,Cisco IOS Software, s72033_rp Software (s72033_rp-IPSERVICESK9_WAN-M), Version 1                                                                             2.2(33)SXI4a, RELEASE SOFTWARE (fc2)We use two cisco WS-C6506-E as our Core Routers. Th...

HiI have a router and im tring to load image from rommon mode but i didnt. i tried a lot and various images but still its not i will provide you the error in belowrommon 5 > xmodem flash:/c2800nm-ipbasek9-mz.151-2.T1.binDo not start the sending progr...

I am implementing a WAN optimization product and I need to getWCCP working for it to work properly - problem is, I only have  2960 switches and a PIX (6.3.5) at my datacenter so there is no support for WCCP there.I have been racking my brain and thou...

dan.tesch by Level 1
  • 1616 Views
  • 8 replies
  • 0 Helpful votes

Cisco switches are now running PVST+,and H3C running MSTP, how can they talk to each other, without changing any configuration on Cisco site. I know that vlan 1 can prevent loop because the BPDU of VLAN1 is standard.But I don't know other vlans(for e...

Hi ,R1 is Router is connected to Frame relay is connect to two Router R2 and R3 with serial with EIGRP 37 and its working fine.R2 and R3 Also connected via fast Ethernet.R3 have loopback connected with 4.4.4.4 and R1 is connected with 1.1.1.1 Loopbac...

abhi-adte by Level 1
  • 746 Views
  • 3 replies
  • 0 Helpful votes