Switching

Will switching to SSO redundancy from rpr-plus cause any issues/downtime or anything of that sort.

Hi,I have a strange behaviour on 3 catalyst 6500 running BGP. In summary, when a VRF looses its eBGP peering with another router, it does not inform its iBGP peer of the withdrawn routes. The difficulty is that the problem does not always occur...Her...

http://www.cisco.com/en/US/docs/ios/12_2s/feature/guide/fs_memnt.htmlthese are great features I am consider adding to our routers/switches. does anyone know what threshold parameters are considered good practice? thanks.

We are in a buying process of catalyst 4500 to replace the 6006 (endofsupport). We are a broadcast tv station with 400 users unified in the same building accross 4 flors with 35xx switchs linked with fiber (GBIC), step by step we are introducing vide...

I need to be able to place a rate limit on broadcasts going out of certain switch ports on a Catalyst 6513 because of the Alcatel devices attached to these switch ports. Is setting "storm control" on the switch port the only way or is there somethin...

Dear all,I run DHCP snooping & DAI.typically all leases from external server are noted and added to binding table. however recently I have noticed that after lease was increased, some entries just assigned were no longer present within the lease peri...

please help analyse this log on 2950 catalyst switch POST set PHY loopback failed.strata_cmic_read_miim ERROR: timeout (addr=0x00 id=0x0D)

Edison,You replied to an earlier post:http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=LAN%2C%20Switching%20and%20Routing&topicID=.ee71a04&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%...

Hello,I need some help adding a new vlan to our company network. Our network has been segmented into mutliple vlans since I began working here, but I've never had to add a new vlan until now, so I'm not sure what I am missing.The router is a cisco 3...

Can anyone tell me the speed between the AISC's and the back-plane on the 6548 blades? And how many ports are supported per ASIC?

Some of our older remote sites are connected via ATM. Two or three T1s come into an Cisco 8510, and from there a 155mbps OC3 connection over fiber to a 3640 router. Lately, I've been noticing that pretty much every one of them is showing what I think...

Hi,Any of you know if this model has problems to power IP phone models 7940, 7960. when I connect these models thet don't turn on, models 7911 works fine.-Regards