Switching

Here's my problem:I have a sup32 running in a 6513 switch running in native mode. My boot var is set to BOOT=sup-bootdisk:s3223-adventerprisek9_wan-mz.122-18.SXF8.bin and my config register is 0x02102.When I reload the switch autoboot tries to open ...

how do i connect to internet using router & i have an public ip purchase from ISP?

Hi,My Catalyst6509 have one VLAN72, and there are some servers in VLAN72, server A IP address is 10.100.74.5, server B IP address is 10.100.74.30. I tried to ping server A, the server A could reply successfully. But if ping to server B, no replied fr...

Hi Guys,I have an issue with a missing password on the "ws-svc-cmm-6e1 module"I have refered to this document http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_14107.html#wp133394I need some clarification here.1. What...

I'm seeing the following errorNov 4 09:33:29.390:%DHCP_SNOOPING-5-DHCP_SNOOPING_MATCH_MAC_FAIL: DHCP_SNOOPING drop message because the chaddr doesn't match source mac, message type: DHCPINFORM, chaddr: 000e.9bac.xxxx, MAC sa: 001a.6bd4.xxxxCisco exp...

Hi I have a problem regarding a printer sometimes not connecting to my network. The switch interface is configured for 100mb/full duplex as is the printer. The switch is configured for portfast and when UTP cable plugged in, the interface comes up bu...

If a router interface has both ACL and NAT attached, and the router also runs routing protocols, what is the order of operation? for example ACL is applied first, then NAT, then routing decision?Thanks.

Hi gurus,Is this possible, configure the router as L2?tia

Hi Guys,had a small Q; I have a switch connecting to a router. The interface settings on the switch is auto and auto. Whereas on the router it's configured to be 100 full. Now I get errors on the interface (both sides). The very moment I configure th...

HiWhat would you recommend for a multicast configuration on dual 6500's with Sup720's ? Each of the 720's have about 20 VLAN's/subnets. No routing protocol. All hosts point to the Sup720 as their default gateway and anything that is not connected ...

All, I would appreciate any ideas on where I can buy specialty hardware to install a 4900M into a 32 inch rack. The customer does not feel comfortable just front mounting it and the supplied rack mounting kit only extends 28 inches. The customer a...

Hi,When I perform a "write mem" on my 5 switches 3750E stack the CPU is climbing to 100% ? Why ?I also noticed that when I have at least 4 switches in my stack the performances are very slow for wr mem, sh run etc ... ????B RegardsOlivier