Switching

hi there!scenario same as herehttp://cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00805e7a23.shtmlbut with LAN connected to the router too.How do I do it with dhcp server on the router and wifi and LAN?Purpose is to obtain...

Hai,I have a requirement to use the 4503 switch which is a cleint for one VTP domain for another network is L2 level. Whether can I manually creat my another network VLAN on the database of this client switch. Some ports of this switch need to have "...

Hi, any got notes on how to use class-map and policy map? i need to pass only exchange traffic thru leased line and the rest must use the existing WAN connection

I am starting to collect hardware to prepare for the CCNP cert.. i found a WS-C3548-XL-EN Switch would this be a good choice for this?, and how many should i get?..(i also may use this to pursue ccie too)Thank you

I am trying to replace a 2wire ADSL modem thus far i have found out i need a device that supports PPPoE and has an RJ-11 jack on it. my isp is ATT if it matters

Somehow my console port is hung. When I telnet to the server and do a show user and I see the following for the console. Line User Host(s) Idle Location 0 con 0 172.20.201.35 ...

guys if two swicthes are connected togather and desired is when one port fails the other port should wait for 18 seconds before interface begings forwarding....how we will do that in mst and PVST can someone please explain

I currently have 2 6500 running on sup2/msfc2 hardware platforms. Since the sup2/msfc2 is end of life, my goal is to replace both 6500 with a 3560, 3750 or something else.The 6500's have about 12 uplinks sfp connections, the 3750 only has four.How co...

I'm in need of some help.my problem that i'm having is i'm switching to a new provider and trying to get my existing network to work with the new isp. i have an existing setup as follows: cisco 2600 with a BRI interface (10.50.17.254) from there the ...

I'm facing some issues with IGMP, but unfortunately know next to nothing about it. The extent of my knowledge is that adding and removing various iterations of 'ip igmp snooping' globally or per VLAN sometimes results in a working config :-)We have ...

all,i've encountered a downtime on one of the ethernet module on my 4500s. after doing a reset using the command hw-module module <number> reset, half of the ports (12/48) were restored. i've opened a TAC case to check on other things. but when i got...

Can anyone please help with this, my users are unable to access ftp sites when both the pc NIC and switch port are set to auto-negotiate. I suspect traffic is generally not being passed properly but that is the main complaint.I have not set any speed...

Hi All,Networks that isolate traffic from other networks using separate mediums are more secure than one that isolates via VLAN correct? So having to networks A and B separate with separate routers, switches, and cabling is more secure than creating...