Switching

I need help.I'm trying to configure one FastEthernet with 5 Vlans,and need to do traffic balancing over two Dsl cards.How can I do it?I have attached the config of my router.Thanks in advance.

We have a new T3 circuit to terminate. Will a 2811 router, T3 module included, handle the job? I'd like to save the cost difference of a 3825 router.

I am currently having cross switch issues, but did some testing between clients on the same switch and noticed very slow transfer times between clients on the same switch as well. I looked at the ports and the incoming/outgoing was very low. The po...

When I do a sh interface on a switch or router, one of the lines reads output flow-control is XON, input flow-control is XON. Does anyone know of a reason you would want to turn this off? I actually thought that flow control is really decided/contr...

I just got an alert for high CPU utilization on our Catalyst 6509CPU utilization for five seconds: 89%; one minute: 91%; five minutes: 90%These seem to be the two culprits....PID 5Sec 1Min 5Min Process16407 72.5% 75.1% 74.7% ios-base 16...

Dear All,In the core switch 4510R the reduntant sup V 10GE shows down in sh module cmd. Also the following error msg in sh redundancy cmdPeer (slot 2) is not available. It is disabled state.What is the problem?The redundancy cmds areredundnacymode rp...

Hi,I have 2 catalyst 4507 as the backbone, and 2 router 2610xm running dlsw: each one connected to each 4507.Vlan bridging is doing in dot1Q sub-interfaces at the 2610xm, and the protocol I use is vlan-bridge.With the bridging active at the same time...

Hi, referring to this document "http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00804c5472.shtml"and the section "Difference between IP CEF and MLS CEF" it says to use show ip cef exact-route <src-ip> <dst-ip> to view th...

Hi all,I have a problem with 7206VXR routers. Suddenly they are reloaded , and I found that it's caused by a watchdog reset. I can't find any syslogs that related to it, but it's stated clearly in the show version output. I found a field notice conce...

Hiplease find the attached file for our current topology and the future topology.According to the current topology , there is a default route on the BB switch to the inside interface of the firewall.ip route 0.0.0.0 0.0.0.0 172.16.1.2We will add a ne...

We have a Cisco 3725 router as our internet gateway. Verizon is our ISP. We were supposed to have our bandwidth increased from 6 to 15MB. Is there a way to confirm the actual bandwidth on the outside interface (ATM1/0.132)? The statement says 6MB.