Hi All, Just a quikie..will the ws-x6548-rj-45 module with the added ws-f6k-dfc work in a 6513 catalyst switch runing IOS 12.1.23e with Sup2 msfc?.Is the ws-f6k-dfc memory upgradeable?.Rgds.Harry.
We want to config 2 6506-E Sup720 MSFC3 with redudant supervisors in the event one fails. I have read the documents regarding SSO but still am not sure how to configure. I have configured both sups with the same configuration and trunked via ethernet...
HiSeveral servers on our main 6509 Server access layer switch have started experiencing problems this morning. These servers have 'Incomplete' in place of a mac address entry in the ARP table. I'm guessing this is looing like a hardware fault with on...
Hi,We have following version of IOS : on our with IOS as CAT 4507.bootflash:cat4500-ipbase-mz.122-31.SG1.bin. We have configured the seperate VLANs with HSRP. I am tryin to debug the standby by debug commands. But not a single message is flashing. I...
Hi, i have a 3750 switch. I want to monitor an ip address and based on that change the route. how it is achievable in 3750 switches.lets say i have 2 routes with different metrics.1) 10.2.1.0/16 via 10.1.1.12) 10.2.1.0/16 via 10.1.1.2I want to track ...
I m having Cisco 2600 series router .. One of my interface s0/0 connected to 2mbps internet leased line.. Now we r going to upgrade 2 mpbs leased line to 4 mbps.. ISP provider telling that we can connect to another 2 mbps leased line to s0/1 and we c...
One of our sites has 3 layers. many of our devices were down this morning. One of our engineers spotted the problematic the switch quickly. His words are attached. My question for you is how can you find this switch?Thanks,Han"That switch has gone w...
Next week I am getting an office ready for VOIP, we are using a managed VOIP service and will be using 28 Cisco 7940 IP phones and 2 Cisco 3550 switches. Computers will be plugged into the phones. Voice traffic is going to a Cisco 3600 router the VOI...
HiI am trying to redesign my network with Cisco devices and would like to have some advise on this. Below are the details and attached the current setupcurrent setupNon cisco devices2 T1s each from a different ISP - /28 networks - one data T1 and one...
Is it okay to do during production hours? Will there be any loss of connectivity, or problems with ARP cache? Do I need to clear ARP as well?Thanks!John
Hi,I am planning to change the root bridge for one of the VLAN by giving prioty in core SW span-tree prioty vlan x.. At the time of chageing root bridge. ..will it effect on VLAN particule VLAN means down/fluctuation etc..Regardssateesh
Hello all I am finding a strange config issue in my cisco WS-C6513 switch while i try to create a L2 etherchannel with my production server.The IOS version is (c6sup2_rp-JK2O3SV-M), Version 12.1(27b)E4 .the config coomands i tried for the ether cha...
All,I am setting up a new network consisting of several different zones. Everything has been planned except for the initial line drop into the lab. I have 2 routers (2 layer 3 ports each, and a 4 port HWIC module (ports function as layer 2 unless bum...
