Switching

Hi all, If i want to make my cisco asa an easy vpn server, what do I need to do?cheers

I need to be able to route the traffic coming from both remote sites, across the PtP and VPN connections, through the web filter. Browser proxy settings will not be used. It needs to be done at the 1841 router. I'm not looking for a complete solut...

Hi,after installing the new IOS release on a Catalyst 4500 and 4500-E I'm not able anymore to establish a connection per telnet or per console with a local username. The login is invald. Username and password are only accepted per ssh. Any hints ?Reg...

after i remove the vip card and pugin into the slot, it can't be recoginzed and fail to work.00:01:19: %VIP4-80 RM7000-3-MSG: slot5 VIP-3-SVIP_RELOAD: SVIP Reload is called. 00:01:19: %VIP4-80 RM7000-3-MSG: slot5 VIP-3-SYSTEM_EXCEPTION: VIP System Ex...

What would be the best way for path selection when we have routers running BGP & with multiple paths to the destination?

Are there any caveats that I should be aware of during this process. I am aware of the change in the slots, but is there any issues that I can expect to encounter?Any assistance would be appreciated.

I have an issue where I will add switchport voice vlan x on to the switchport, the ip phone (polycom talking cdp) will work fine on some occasions but not others. If I reboot switch the vlans will not come up automatically on the voice vlan, however ...

Hi, I need Switches, IPS, Load Balancer and Firewalls. But its hard to find right one.Switch Specifications:Device should have at least 24 x 10/100/1000 Base T and + 4 x GBIC/SFP ports. SFP ports can be filled up with 1000BaseSX, 1000BaseLX or ...

In the Stack Switch message in member Stack in booting time is that reloading because of master reload always but master is running smoothly and not giving the switch detail of member

What causes this problem?C3500XL POST FAILURE: MII Test: FailedC3500XL POST FAILURE: Ethernet Controller Test: Failed

Dear all Cisco experts,I need an urgent help for the design I am currently working on. We have a customer who has got 2*6506 (old Chassis) and planning to upgrade. At present they have got following modules installed in them:Core 6506*1Mod Ports Card...

Which command is the most ideal one to identify a switch as L3?

We typically have multimode fiber runs across our very small college campus. We are buliding a new building that is far enough away that we need to run a single mode fiber to tie the new building to the backbone. I will be deploying the Cisco 3750 sw...

Hello, Question I have two cat4506s connected via an etherchannel. Do I need to enable "qos trust dscp" on the etherchannel interface to get markings from one switch to another? Since it is a trunk shouldnt it already accept the QOS tages and not wip...