Switching

Hello,I would like to know if it is possible to configure CBWFQ (service-policy output) in a gigabitethernet subinterface (dot1q) in a 7301 router.I have seen that this feature is available from 12.2(20)S but the document says that the feature is ava...

Hi all,I have searching some specifications details, but i'm a litle unsecure about this, so here it goes:I'm searching for the cheapest "Fully nonblocking architecture" LAN Switch.What i mean for "Fully nonblocking architecture", is the summary thro...

Hi, I have been trying to configure a static PAT on a 1761 router to get to an SMTP server behind this router. I have configured it, but when I am trying to telnet to the IP address of the router (public) on port 25 I do not get anywhere, even thoug...

Are Jumbo Frames supported on the 2960 switch for Etherchannel links? I can't find anything in the documentation. I have found that the 3750 states that the MTU must be the same for the links to come up. I had jumbo frames working just fine until I s...

I am looking for a command to clear single/dynamic arp entry speicific to a paritcular IP or interface on 7513 & 7507 routers. We do not want to clear complete arp table. If there is any command avialable please assist.ThanksSuhaila Ahmed

Hi Friends,Can anybody give few difference between Ripv1 & Ripv2.It is most appreciable.Thanks in advance.Regards,Naidu.

I have a Cisco Wireless Router with 2 WAN ports and I want to use 2 modems, as I have a DSL and Cable internet line, with one being a backup just in case I lose connection with the other. How would I go about setting this up? One modem is on Fa0 and ...

Hello, I've been studying for my CCNA for some time now and I consider myself quite the geek/nerd. I am setting up some servers and high bandwith video content on my home network as well as VMWare and some other nice toys on my workstations.I'm look...

Hi,My question is How can I configure NAT with Router Cisco 7200 using virtual interfaces VLAN or Loopback?I have to configure One vlan with Private IPs and the other with public IPsI tried with this configuration but it doesn't work. Any suggestio...

Are there any folks on this forum using Management-only VLANs with QOS?We are seriously looking into doing this, not only for management of our Cisco switches but for security purposes,and maybe combine it with QoS to make management a littel more ro...

HI,How can i created a DHCP server on a switch? Please help.

HiI've got cacti running monitoring the switch network interfaces. I'm a little confused with how the graph depicts incoming and outgoing traffic on the interface. Can someone please exaplain what is categorised as incoming on an interface and what ...