Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

What does the 2nd statement means?ip route 0.0.0.0 0.0.0.0 192.168.229.1route inside 10.242.26.0 255.255.255.0 192.168.116.1 1I know the first one tell the router to send all traffic destined to the internet to send it via 192.168.229.1, but the 2nd...

insccisco by Level 1
  • 2427 Views
  • 29 replies
  • 0 Helpful votes

I have an 3560 running 12.2(40)SE IOS. This switch has two trunks in an etherchannel, connecting to a 6509 running 12.2(18)SXF12. Would I apply the *ip dhcp snooping trust* command on both uplinks that make up the EtherChannel?

Mike Mott by Level 1
  • 705 Views
  • 4 replies
  • 0 Helpful votes

I have configured Netflow on the PFC. I did this by using mls commnands. Do I also have to configure Netflow on the MSFC?ip flow ingress & ip route-chache flow commands enable netflow on the selected interfaces,correct? but I havent used this comman...

lm20ele by Level 1
  • 510 Views
  • 1 replies
  • 0 Helpful votes

Resolved! VTP Questions

In a campus scenario where each switch will have one dedicated subnet, is there a best practice to follow to implement VTP?I was reading in the BCMSN book that VTP pruning should not be enabled on the access layer switches. I understand that enablin...

Hello,So totally new to cisco it's not funny! I just bought a cisco 1751 32m/16m on e-bay, and tried to load a new ios on it. it came w/ 12.2(4) and i loaded 12.4(17a). Thankfully I decided to keep the original in flash, because when I tried to bo...

Resolved! ip accounting

Hi,In relation to the ip accounting output-packets command, if packets are being accounted for then can we guarantee that the packet has left the interface?In what order does ip accounting take place? I presume it would be after output ACL, NAT and ...

hi therei have an ASA5510 with the following setup:e0 - outside interface-212.188.x.x/28e1 - inside if - 192.168.3.x/24 into 2960sw pport 10 vlan 1-switchport accesse2 - dmz if - 172.16.x.x/24 into port 14 vlan 40 switchport access.linux server plugg...

SOL10 by Level 1
  • 789 Views
  • 6 replies
  • 0 Helpful votes

I have a Cisco Catalyst 5500 with a SupIII engine with a Dual Port 1000BaseSX Uplink Module (WS-U5534-GESX) and I'm connecting to an Extreme Networks device with an SX GBIC connector. and its not working.2 questions.1. What diameter does the Cisco up...