Switching

Can you add a secondary IP address to a VLAN? Scenerio: I am migrating devices to a new subnet and want to use the existing 3550 switch until the migration is complete.

Having two cisco 4948 switch ,Want to uplink with two Links one with Ethernet port 10.XX n/W and other Fiber Uplink with 97.XX N/w also requirement is such that 1 to 16 port work with 10.XX N/w and 17 to 42 with 97.XX n/w and 43,44 port use for trunk...

Hi,i have a 2821 hooked up to my isp and my lan. the isp interface is configured with a ip only routed inside the isp network. the inside ip is routed worldwide. now when i try to connect to a network outside the isp directly from the router the pack...

We have the Catalyst 2950 device (C2950-I6Q4L2-M) Version 12.1 and our Windows XP clients can join our Active Directory domain but our Windows Vista clients cannot connect/ping/remote the domain controller and thus can not join the domain. Any ideas...

I have been trying to get this router setup properly for a few days now, and realised that not knowing IOS is a big disadvantage as SDM is perhaps "flaky".So far I have managed to get ADSL over POTS by sending over "ppp pap sent-username user@domain ...

On my catalyst 3560 i can look at Switch Receive Bandwidth Percentage Utilization and Switch Transmit Bandwidth Percentage Utilization by using "show controllers utilization" command. What is the command can i use on cat 4500 and 6500 ?

We are trying to setup L3 switching. The layer 3 switch has multiple VLANs and is routing fine between them. On the l3 switch I routing all unknown ips through an actual 1841 router that is locally on one of the vlans and connected to the l3 switch. ...

i have one 2611xm router.plz give me information that ssh and sdm support on this router or not.and do & grep command avilable on this or noot

I have confiugred the MHSRP successfully. I am able to provide the redundency and load balancing. But problem is that I am not able to track the Interface connected with WAN.It is ethernet interface and I mentioned it in HSRP configration, but when ...

Hi, I have a 3750, with the following acl:access-list 1 permit 1.1.1.1and following commands in the console:line con 0 access-class 1 in exec-timeout 20 0 logging synchronous no exec history size 256 transport preferred none transport output none esc...

Hello can someone help because my cisco 1603-R is only looping System Bootstrap, Version 11.1(10)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Copyright (c) 1997 by cisco Systems, Inc. and repeating again, do you have any suggestions how can I fix this ...