Switching

Hiwhy in IPv6 only the neighbor Command in just 1 side works not an the Both to form the ADJCHG ""*Mar 3 01:37:41.467: %OSPFv3-5-ADJCHG: Process 1""ipv6 ospf neighbor FE80::CE01:7FF:FE1C:0can u explain plz10xs

HIIts Possible ti cinfigure 2 bgp route-reflector in the same As?if So pl list the Situation for that..many 10xs

hi allI am in progress of creating a site to site tunnel between 2 sites, we need to access e-mail, internet and rdp from site A on site B, and we need to access rdp, telnet and mail from site B to site A, can anyone tell me what i need to do to crea...

when I configure FWSM-6509 multicontext.I configured 2 context.diagram:vlan22--FW1--Vlan12<-->Router<-->Vlan22--FW2--VLan12Vlan 22 : outsideVlan 12 : DMZ but error :6|Mar 02 2007 19:38:12|106025: Failed to determine security context for packet: vlan1...

Hi, Using PVST+ I have two 3550's linked via a Gig uplink (cost 4 to root) and a fas eth uplink (cost 19 to root).Switch A is my root bridge by lowest priority. If I guard the RP i.e. Gig 0/1 on my root bridge and leave the fast ethernet port ungua...

hello,i must configure a backup solution for a ipsec soho connection with pppoe dialin.config for ipsec ( works fine):!!hostname test!!crypto isakmp policy 10 encr 3des hash md5 authentication pre-share group 2crypto isakmp key xxxaddress 1.2.3.4!!cr...

i 'll try to use the new feature auto image update. configuring option 125 => name of the text file, i am sure to type the name of the file in hex correct.But the switch does not find these file. In the capture i can see that the switch is adding let...

Hi,I need your help.. I have configured my pix501 outside and inside ip address... I think everything is in place but I still cannot access the internet. I am attaching my present configuration.. Thanks

Hi,Just wondering if any of you guys know of a product that will test the integrity of data traversing a flat network. I have had a lot of various intermittent issues on a customers site over that last number of months. I have tried everything except...

Hi all, am i correct in saying a mac address cannot exist on more than one port on a lan, except for the uplink ports leading to that mac address ?

Is there a switch (not Cisco) with 24 10Base-FL or 100Base-SX ports to replace a Catalyst 6509 WS-X6024-10FL-MT module that has 24 10Base-FL ports? Cusomer has 48 remote access-points (old AP4800)with a transceiver AUI-10BaseFL Fiber connetected to t...

I want to permit helpdesk people to change some interfaces parameters for let say fastethernet port only. Since my uplink are Gigabit, I would like blocking them any changes on those.Does anybody know a way to control that ? I am able with the privil...

Is it ok to form an etherchannel on 6500 with qos enabled and in differnent queue and threshold on LAN ports?