Switching

If I have a standard 2924 switch and I want to connect it to a 2950 switch, what coding do I need to include since the 2950 does not support ISL trunking? thanks

Hi, Recently I had to trouble shoot 6509 switch, high network latency issue. To my surprise I realized that there is no command (at leat to my knowledge) to check what is the traffic coming in and going out (show mac is giving some octect based outpu...

Hai frenz,Can somebody explain about RTT, how do u define the connection slow or normal? when do the ping test how can the output help us. Please do help me...i need to know how this can help in testing my internet line ok or not. TQ

config-register on Cat6509(sup720, Native IOS)[config-register RP] Sup720-6509#sh ver........Configuration register is 0x2102[config-register SP]Sup720-6509#remote command switch sh ver........Configuration register is 0x101If Cat6500 is rebooting, w...

Hello, I was trying to establish NAT between two vlans. The configuration is:interface vlan 14 ip address 10.2.100.254 255.255.255.0 ip nat inside ! interface vlan 7 ip address 1xx.xxx.xxx.126 255.255.255.192 ip nat outside ! ip nat pool CONVERSION 1...

I'm having troubles with a 3400G catalyst with 12 combo gig ports. I'm using the device in a foreign collocation center and all I require from it is just simple switching and trunking.Current outgoing rate to the core network is ~750 Mbit/s and avera...

can someone explain why from a pc directly connected to a router ethernet interface pings the ethernet interface ok but cannot ping the serial interface on the same router. Serial interface is connected with back to back cable with another router and...

Working with Catalyst 2960 IOS IOS 12.2(40)SE, when confire "storm-control multicast level 30" on ports 1000Base-SX some times the port goes to err-disable state with a log message of multicast storm on port.The level of multicast traffic on this por...

ERSPAN, what platforms is it supported on? I have found only the Supervisor 720, is it supported by L3 images on the 3750 or 4500's?Thanks!Aaron

Hi all,We have to design an IP schema from ground up, for two offices connected with each other over MPLS link managed by ISP.The two offices would have centralised administration but would not be sharing any hardware components across.The need is to...

Dear all,please explain the significance of WS in <b>WS-C3750G-12S switches</b>thanks,phani

What is the best method to change the destination ip address of a packet? Specifically, I have an application hardcoded to connect to a apps server at 10.1.1.1. However, the apps sever is actually in 192.168.1.0/24 segment, with a ip address of 192.1...

I have a network based on 3750 switches and several VLANS running voice and data applications. We are deploying a 3rd party PTT (push to talk) application on our Cisco phones. In order for this to work the vendor has asked that we enable multicast r...

helloi have "694742119 brodcast" on the Gig0/1 connected to DS-1.IS THE Brodcast Stoem command Kill this Brodcast.if so what is the Level do i need to Assigj?Mercie

Hi All,Bit of a strange question, regarding MSTP on a 6500 running 12.2(33)SXHI have picked up a difference in the docs between the config guide for this version and the previous version.The previous version has a chapter on pre-standard MSTP and say...