Switching

Hello,Two of my 3750 switches in a stack are logging a lot of stack linke changes. Is this due to a faulty cable/port? If I change the cable and it persists, what would be the next step?Thank youChris

Hi, I have seen somewhere in a catalyst config, something related to ip cef. But, as far as I know, Cef is only present for layer 3 switches, starting from 3500 series, isnt it? And even if I can add an ip address to SVI (vlan 1, vlan 2...), this doe...

Hi All ,I want to Know equivalent model for Cisco 2950 switch .The switch should have Gigastack & should be stackable.Please revert ...its urgent.Come on Guys........Cisco 2950 is not available,as it is end of life.Please revert..

Hi All,i have many 2950 as edge switches in my current infrastructure.The 2950s is stacked using giga stack cables and a loopback is done.Recently there is a need to increase the number of ports. Cisco 2950 has EOL i believe. What switch should i pur...

We are seeing slow file transfers from EMC to the end XP stations after enabling MLS QOS on the access layer 3750 12.2(25)SEE3. I believe the EMC Celerra runs Linux and utilizes Samba for file sharing. I ran across an earlier post.http://forum.cisco...

I am having 1 Cisco 2651XM Multiservice Router with 2 Fast Eth. (Fixed). Can anyone pls tell me if I can install one NM-1E - One-port Ethernet on this.Thanks in advance.Anis

HiI have a network using 3 * 2950 switches. I am getting very high no buffer and packets ignored counters on one of the interfaces on the switch. THis interface is connected to my backup server - i only see these errors when the backup run. Any idea ...

As I try to configure this cisco, i notice that it does not support the command modem and even the first system configuration dialog will generate error after it finish the wizard. the ios version: IOS (tm) 3700 Software (C3725-I-M), Version 12.3(6b)...

Hi all,I have a pair of Cisco Catalyst 3750. I connect this two switches using stack cable.Can the two stackwise ports to be configured as trunk?regardsWan Hwai

Hi all, can anyone tell me, when a pc makes an arp reqauest and the device is not on the local switch, does the switch cache every mac address thats not local on its uplink port ?

Is it possible to use DUAL ISP's for load-balancing a LAN to LAN IPSEC using OER? The other side of the VPN is a Cisco PIX 515. I do not see hardly any documentation out there and don't have the equipment to test....

I have a 3550 switch where I work at that when I console in and start a session it reboots itself causeing all kinds of trouble. Any suggestions why and how to fix?

Using police (because rate-limit doesn't work on a vlan) to control traffic in and out of a VLAN, but it isn't working. I want to limit traffic to 256k/386 Burst, but when I do a speed test I am getting FAR more than that.here is my config:class-map...