Switching

Hi,I want to connect two 1841 router back to back with fast ethernet port.Please help me how to configure HSRP on two routers connected back to back through fast ethernet port and how to configure fa port to connect the two routers.Thanks,Sachin

Does some one know the maximum number of tunnel GRE that a 3750 EMI switch can support simultaneously?Thank you

Hi NetPro,currently my network using PVST, just that i would like to try upgrade to Rapid spanning-tree. anything i need to aware ? what's the condition ?can i directly configure the core switch and change it from PVST to Rapid spanning-tree ?Regards...

Hi Netpro,how do i start change the workstream on multicast , currently i am using 224.x.x.x whereby now i wanna change to 239.x.x.x and turn off 224.x.x.xany idea ?regards,Jackal

Hello, I have problem with my Cat. 3350. It cannot boot up and it fail at the POST.Here is the error message as below.Unexpected exception to CPUvector 700, PC = 0 -Traceback= === Flushing messages (00:00:13 UTC Mon Mar 1 1993) ===Buffered mess...

COULD ANYONE TELL ME WHATS WRONG WITH THIS HSRP CONFIGURATION?THANKS.NOTE:interface GigabitEthernet1/1 OF CORE SW 1&2 connected to edge switch 1interface GigabitEthernet1/2 OF CORE SW 1&2 connected to edge switch 2VLAN 100 IS THE MANAGEMENT VLANCORE ...

Hi NetPro,currently my port-channel config at Cat6509 as below.Interface Port-Channel9switchportswitchport access vlan 64and used at Cat4507interface GigabitEthernet4/29description Ciscoswitchport access vlan 64spanning-tree portfastchannel-group 9 m...

First Question:I have heard that you can also transfer files, and upgrade the IOS for a network device (a catalyst 3550 for my case)using a console cable. I know that there's the common tftp tranfer method, but I'd like to know how do I go about usin...

I am finding conflicting info among cisco documentation for the acceptable threshold of collisions on a ethernet segment. A CCDA question was that the Cisco standard for collisions was .1% of total throughput. Divide collisions by packet output to ...

I am deploying a 5505 in a hosting environment. The following is the configuration.WS-X5530WS-X5302WS-X5224WS-X5224WS-X5225RWe will have about 70 servers in the next year most will be in 2 VLANs. 1 VLAN will have about 75% of the servers. I have 2 of...

what is the best practice design of having a redundant core switch?the scenario is;2 x 65002 edge switches in each floorthanks.

I would like to ask what is the cause when the LED of the swicthes blinking to fast.....