Switching

Hi, I've stacked 4 3750-48TS together, and configured master member switches.But what happens when 1 of them fails, and i put a new 3750-48TS into the same location, will the others configure it to the same as the old. And what about the IOS? Will it...

Dear sir,Can i get 3500(l3 switch)datasheet means how any vlans it will support and functionality if any diagram is there that will be nice.Regardssrinivas.D

Hi all, if I want my router to terminate my dsl connection via modem, what command do i need to use to make sure it gets the wan ip from the provider, and do i need to put the username and password on my ethernet interface for the chap connection, wo...

Hi,I'm thinking about some usage of HSRP compare to Stack. Need advice to verify if I'm correct.I currently have two L3 (non-stackable switch) configure HSRP in SVI for my clustered firewall gateway (each firewall is physically connected to each swit...

I have a scenario where i want to a certain vlan to browse the web through our seconfary firewall, i know thsi can be done by an access list, or policy based routing but sure of the syntax any help would be appreciated

Anyone use a pda to serial connect to their switches and routers?If so what do you use for pda, client and adapter?tks

Here is the situation:One switch is configured as the VTp server witn interface VLAN 1 shutdown. Other Vlans are configured on that switch, and one of the created Vlan is the new management Vlan (let's say vlan200).Trunking is enable on the Gig inte...

Hey guys - We recently dropped fiber into one of existing locations that has a T1. This t1 (serial 0/0/0:0) is configured as the primary link back to our main campus. We have 5 35xx switches down stream of this router, and so far, have 3 different ...

I am working on a Rack Clean up project. I can not remove any wire until I know 100% what device is attached to my switches. I am dealing with Cisco 2950s and 3750s. I can not trace the wires because I am not allowed to go under the Data centers floo...

What is the equivalant IOS command for the CAToS command "set port host" ?Thanks in advance.DTA

I have a 3560 with routing enabled and am missing something in my configuration...The attached diagram shows how I am set up now.I enabled EIGRP on the Layer 3 switch, and added the networks x.x.30.0/26, x.x.31.32/27, and x.x.153.0/24. The default ga...

Hello,Does anyone know if it's possible to text message another user that is connected to the same switch? In my case it's a Catalyst 6509 running CatOS 8-5-2.Thank you.

Hi,Yesterday we've experienced slow network performance. My core is the 6513 with dual sup2's (Catos 7.6(16) and msfc2 (12.1(11b)E)cards setup in hsrp mode. Switch uptime is 414 days, no issues until yesterday.In my efforts to troubleshoot this (no c...

for exam purpose:If i have to manually configure an stp root bridge and if the network has distribution switches but it also has access switch which one should i select if the access switch seems to be in the center of the network (access switch has ...