Switching

HI Experts!vlans that r pruning eligible;what this does?10xs for ur InfoWarm Regards Ali

Hello,I have a Cisco router trying to communicate to a remote host on the Internet through our gateway Router. Both routers are on the same subnet. We kept having intermittent communication issues. During our troubleshooting, we noticed that the A...

good morning,i need to attached on a port of my WS-C2960G-24TC-L a VMWARE server.In a VMWARE server i have many virtual switch.How i have to configure the port of the WS-C2960G-24TC-L, where are linked whith the VMWARE server? like desktop o like cis...

Hi all, when I have an internet connection, and site to site vpn, how do i stop the traffic getting natted when it goes through the tunnel but not the internet?

Hi,I have a 6509 with SUP1A. I want to insert one more gig module WS-X6148A-GE-TX. Do i need a restart after inserting or will it get recognized with restarting the switch.Regards,K

Hi all, when I want to make sure that a problem is the server, not the network, do I monitor the repsonse time to the server againts the network, or do you monitor the application somehow? whats the best tool foor this ?cheers

I have got the 6506 with the two sup720 in slot 5 and 6.Whenever i remove the active sup720 from the slot 5, the switch gets booted up then the standby comes on line which takes lot of time, do i need to do any spesicif configuration to make the stan...

The following is the Gateway Router external interface counters::::stEthernet0/1 is up, line protocol is upHardware is Gt96k FE, address is 0013.c3c2.6c8b (bia 0013.c3c2.6c8b)Description: INTERFACE TO CHN_TVM LINKInternet address is 10.0.0.2/30MTU 15...

I have a number of Catalyst 65xx switches running CATOS. The default logging level (5) generates the following types of messages when a connected host powers up and down:2007 Feb 19 13:42:36 AKST -09:00 %ETHC-5-PORTFROMSTP:Port 3/45 left bridge port...

Can someone please clarify for me.If you are part of a vlan and someone on that same vlan installs a packet sniffer, will he be able to see traffic other users on the vlan are sending ?I know about SPAN and how it works but please clarify the above f...

a CCIE i use for consulting was discussing our plans to replace five 3548 XLs. We were thinking to go all gig. He explained that the PCI bus of a PC would not actually allow more than 200Mb of throughput. Is this legitmate? If so i would question the...

I'm getting a lot of late collisions on the WAN side of my router (Cisco 2801.) In the log I am also seeing errors every few minutes where that interface will come back up. I am having throughput issues with this router and I think this may be a dupl...

Hello,I am trying to create a vlan on a 6509.cc_6509_02(vlan)#vlan 1082 name ABCIt doesn't seem to like a number over 1009. I know you can create vlans up to 4096. I tried to create it from the config t prompt using vlan 1082 name ABC and this see...

Does anyone have solid documentation that an 1811 Security Router can be configured as a GRE tunnel headend device? I've yet to locate a definite 'yes' in the documentation I have.Thanks,Marc