Switching

hi can copper and fiber port co-exsist in one port channel ?

hi can copper and fiber port co-exsist in one port channel ?

Hi,I have configured jumbo frames sized as 9198 in a 4948 switch using interface config mode inc the ether channel configured as trunk port.But after 10 min the switch stopped forwarding the frames.I would like to know is it possible to pass jumbo fr...

Can tftp server run on XP? I am getting %Error opening tftp://192.x.x.x/file name.

HelloI have 25 Cisco routers in our companythe two 2600 routers support NTP no problem.The rest of our 1600 and 1700 do not seem to support NTP.If i go into privileged mode and configure terminal and do a show command, NTP is not displayedIf I type #...

Hi All! Happy New Year!Our Cisco ASA is connected with two inside interfaces to internal Catalyst6500 switches.I am using OSPF for routing. But in the routing table of ASA i see only one interface to get inside switches. How to get OSPF to use both i...

On a network where you are runing a single VTP domain and you require to run 2 switches as VTP Servers for resilance is it necessary for these 2 switch servers to be directly coupled or can they reside separated by other switches running in client mo...

I am reading up on BGP and a bit confused as to the difference between sh ip bgp & sh ip route...Does BGP maintain its own table? - if it does, how does it correlate with the routing table?Thanks

Hello. I bought Kingstone 512MB CF memory, because it was over 50 times cheaper than the same module from Cisco. The module works flawlessly in 2821 and 2851 ISRs. But when I plug it into SUP 720, it is not even detected.I have tried variety of thing...

Hi...We have a 6509 CatOS with two Sup II (no SFM) acting as a core switch for a customer's network. I noticed that when pinging the active supervisor engine, the response time is perfect (< 1ms), but when pinging the msfc, the response time is about...

Hi Guys,I have some virus problem in my network can you pls guide me step by step how to find out which node is virus infected.

Hi, I have seen the following ACL entries in a running config of a router, are they valid ACLs? And what do they mean? Thanks.permit tcp 10.16.8.0 0.0.0.64 host 10.1.2.16 eq telnetPermit 10.16.0.0 0.4.255.255permit ip 10.16.0.0 0.3.255.127 10.16.8.0 ...

Appreciate help on the following: On a cisco WS-C4507R, Version 12.2(25)EWA1, I tried to remove 3 existing snmp-server host configuration and add 2 snmp-server host statements:no snmp-server host 1.1.1.1 public no snmp-server host 2.2.2.2 public no s...