TelePresence and Video Infrastructure

Is there a way to make the web interface of meeting place express respond on a different port number and using a domain name other than the name of the server?An example would be if a company had a web site (www.domain.com) hosted on port 80 of a pub...

I am having problems adding an attendant console after intergrating with active directory. When I go to users and add attendant console ac user it gives me an error.

In the web page of the MCU, I try to Create a Conference, I select the prefix (default 81 type Video) and I enter the unique number and when I do click in the boton "create" this message is showed: Error: No Resource are available. And the EMP module...

Looking for a solution to integrate/ monitor new polycom phones into cisco works or similar software to monitor hardware issues. I am suspecting that added the phones in between the switch and pc will make monitoring the pc in our current setup impos...

Before going to implement telepresence to a customer, who is not fasing any bandwidh problems, which all questions are to be considered?

We have CUVA running with our CallManager Express and 7960 phones. It works very well for internal calls. However, when I try to dial outbound calls to the PSTN, the call never completes. Quitting CUVA allows the calls to go through.I should point ou...

Hi,direct videoconferences between Tandberg Edge 95 Endpoint work with very good quality (384k, H264)But conferences to the 3545 MCU have a really bad video quality (audio ok), with the same Codec H264 and Image Size CIF. Presentation Mode with H239 ...

Dears,      i have VIC2-2FXS installed on C2801.the first port is not working.the second is not working.i replaced the VIC but problem still exsists.ext,2628 works / ext,2627 not work.attached debug output.

Is there night mode on callmanager

Hi,I have configured a E1 PRI at Germany (CustomerA).CustomerA is complaining that his clients are reporting that when they dial CustomerA they get busy tone 1st time and then when they redial the call goes through and its intermetent and not always....

Error from authentication subsystem.hr=0x8004054B (The specified domain either does not exist or could not be contacted.\x0D\x0A)There may be additional information in the Application log (use the system Event Viewer).Please see your Cisco Unity syst...

I have a solution with a hybrid bridge and an endpoint that are in the same VLAN but the Endpoint drops around 20 minutes every time. In the Firewall logs i see the Endpoint sending packets for the bridge to the firewall in stead of just directly to...

Hello:I want to do a videoconference between two endpoints through a gw. I choose 128 Kbps, and I have only the audio. The GK admits the call for the gw but in the openLogicalChannel phase I have this:value MultimediaSystemControlMessage ::= request ...

Is there any command to check voice services on 2821 gateway routers example:show dial-peer show voie portsh network-clocksh ??????