Im having some little problem anybody have idear on it,the problem is i have site to site connetion and i connected ericsson pbx md110 to each site,but when im calling from each site the calling does not appear on it unless the person pick the phone ...
We are a large university, looking at buying an MCU to support various departments video endpoints. We have analog, ISDN and Cisco VoIP phones and want to support multiple VTadvantage video calls as well.I am looking for suggestions between a Tanber...
I have cisco 2821 with WIC-2T EVM-HD-8FXS/DID High density voice/fax extension module with 8FXS/DIDEM-HDA-3FXS/4FXO 7-port voice/fax expansion module-3FXS/4FXOObviously Fax will be connect with FXS port and Nortel PBX will connect with FXO and Leased...
Is there a way to make the web interface of meeting place express respond on a different port number and using a domain name other than the name of the server?An example would be if a company had a web site (www.domain.com) hosted on port 80 of a pub...
I am having problems adding an attendant console after intergrating with active directory. When I go to users and add attendant console ac user it gives me an error.
In the web page of the MCU, I try to Create a Conference, I select the prefix (default 81 type Video) and I enter the unique number and when I do click in the boton "create" this message is showed: Error: No Resource are available. And the EMP module...
Looking for a solution to integrate/ monitor new polycom phones into cisco works or similar software to monitor hardware issues. I am suspecting that added the phones in between the switch and pc will make monitoring the pc in our current setup impos...
We have CUVA running with our CallManager Express and 7960 phones. It works very well for internal calls. However, when I try to dial outbound calls to the PSTN, the call never completes. Quitting CUVA allows the calls to go through.I should point ou...
Hi,direct videoconferences between Tandberg Edge 95 Endpoint work with very good quality (384k, H264)But conferences to the 3545 MCU have a really bad video quality (audio ok), with the same Codec H264 and Image Size CIF. Presentation Mode with H239 ...
Dears, i have VIC2-2FXS installed on C2801.the first port is not working.the second is not working.i replaced the VIC but problem still exsists.ext,2628 works / ext,2627 not work.attached debug output.
Hi,I have configured a E1 PRI at Germany (CustomerA).CustomerA is complaining that his clients are reporting that when they dial CustomerA they get busy tone 1st time and then when they redial the call goes through and its intermetent and not always....
Error from authentication subsystem.hr=0x8004054B (The specified domain either does not exist or could not be contacted.\x0D\x0A)There may be additional information in the Application log (use the system Event Viewer).Please see your Cisco Unity syst...
