i can no longer session or telnet into the communication media module. Is there away to connect to the module directly.
i can no longer session or telnet into the communication media module. Is there away to connect to the module directly.
Hi,what is the different of CPU loading between "codec g711ulaw" and "codec g729rb"? what codec consume more CPU loading?What is the adv if I enable the "codec g711ulaw"?rdgs
Hi all,i'm trying to configure DMM 4.1 for Future Deployment; but i've some problem.More details:I can open the Future Deployment page and i'm able to configure one task; but later when i try to open the same page i see only a white page and some exc...
We've got the IPVC-3515-MCU12 with version 5.5.0.0.54 to integrate with CCM using SCCP. But, we find CCM cannot register it. Is there any configuration setting need to aware for it?
I have older 7940g's which register and pull down configs fine. The 7941g's will not. Im at a total loss.
What do I do to force older phones that were previously used to pull down a new firmware from my cucm 5.13 config server?Thanks ahead.
Can someone tell me if there are special licensing requirements or other special configuration setups for a video conference call with the cameras? Say 5 video phones at once?
I have 2 sites and have a MPLS WAN with T1 bandwidth. I want to implement QoS and want to classify Video and voice traffic.Should I classify Video based on tcp ports. If so, can someone tell me what the ports are?joe
Has anyone ran into remote gray screen on VTA calls? We upgrade Hardware (severs)we kept CCM 4.1.3 and are using MGCP. It was working before upgrade. We did a backup and restore to the new severs.UPDATE: Have upgraded my 7970/71 to 70.8-3-3SR2S. it w...
Hi,I need to estabish videoconferencing beetween endpoint, which are equipaded with the Cisco IP Thelephony 7960 with the video capacities enabled and Cisco Unified Video Advantage software and Cisco VT Camera II. The version of the Call Manager is t...
Where can I get the material of configuration about the Cisco IP/VC 3510 Multipoint Control Unit?
HiFor what situration I must implement the gatekeeper? any pros and cron of gatekeeper?rdgs
Hi,Topology: [Intercom] -> fxo--[gw 2821] -> [cucm5] -- [phone 41851]The configuration:dial-peer voice 41851 voip destination-pattern 41851 session target ipv4:172.26.240.10 dtmf-relay h245-signal codec g711ulawvoice-port 0/0/0 cptone CA timeouts cal...
Hi,I config the as54xm and it is working properly. I find that there are a lot of CDR in log file. how do I disable the CDR to syslog and keep the cisco alarm log (level 5)? How do I config router that the CDR to RADIUS server only?rdgs
How I can configure the SCCP protocol and add the Cisco Call Manager (TFTP Server) to MCU 3510?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
05-02-2025 01:27 PM | ||
05-02-2025 12:56 AM | ||
04-30-2025 08:17 AM | ||
04-15-2025 12:31 AM | ||
04-14-2025 12:25 PM |