What is the maximum number of IP Phones that can be supported over a WAN link to a branch office. The WAN link would need to support both voice and data. Is LAN/WAN QoS manditory. Is a Voice VLAN at the branch office an absolute requirement. The ...
Does a set-top device exist that will allow me to deliver on demand and scheduled content from my IPTV setup to a standard TV already installed in each classroom ?
I am working on sending IPTV On-demand video programs to internet users with high speed access. Does anyone know of an easy way to allow this access (through the firewall) from the IPTV Guide or a URL? Most of what I get is a "RSTP connection failu...
hi,we are settig up a VOIP network.my problem is ..I have one E1 from pstn and the pstn switch is configured in such way that it support only to switch not the hdsl modem or dirct AS5300 but i have Hdsl modem connecting to my AS5300 gateway.so, plea...
Hi. I have a 3640 running as a gatekeeper. I had configured several zone prefix in the local zone. I'm a little concern about the limit of this table, Do you know what if there a maximum of zone prefixes or just depend of the memory of the machine?Th...
I am looking to export all the data from my old 3.1(3A) box to a file(s) and then have it imported on a BRAND new machine with 3.4 already loaded...will Dirt accomplish this?
On the 6608 blade is it possible to set the secondary TFTP server address from the CatOS CLI ?The 'set port voice' CLI command only appears to accomodate a single TFTP server address. How can you set the address for a secondary TFTP server - do you h...
I am looking for a solution that will allow me to deploy VoIP to remote sites that will use standard analogue phones as extensions from a Nortel Meridian PBX. I am looking at the VG248 to bring the phones in then packetise the voice and forward onto...
Is it any solution for H323v4 gateway As5350 throught NAT Router (cisco7206)to register to gatekeeper. I hv problem to register my gateway As5350 via NAT to gatekeeper.
I Have an ATM WAN Network, I need to carry multicast over IMA interfaces, I have one 3745 and four 2650XM, the 3745 is the central site, the 3745 is connected to one Avaya Cajun Switch, this Avaya has interconnected the multicast host, the Avaya is r...
We have a IPTV 3417 Starter Server with Optibase MovieMaker 200s capture card. My problem is that when i launch Window Media Endoder to capture video/audio i get the following message " No audio input device detected therefore live capture options ...
Hi, i have a vg200 in 12.2(19) IOS. I try to enable tacacs+ authentication but it does not work. Is there any sample configuration to turn on tacacs+ authentication for vg200.
I have 2 leased lines with Multilink PPP. I have configured QoS for the video conference and I'm not sure how I configure the Burst Size with the priorty command? Do I have to use it?I have set the priority command to 1000Kbps.Thanks in advance
