TelePresence and Video Infrastructure

Hello, My configuration : CUCM 10.5.2 / CUPS 10.5.2 / ExpressWay X8.7 I have a problem with traversal calls. If a make a call from outside of network (I use Jabber Video for my test) to inside (hardphone) and I end this call (before I answer with my...

Hi, I have a client with a VCS Control appliance running X7.2.2 s/w.  QoS has been set to DiffServ with a value of 34 and the VCS rebooted.  Packet captures show that no DSCP marking is being applied.  The alarm status page shows no errors or warning...

Dear All We Are a system integration company and a Cisco and an AMX partner Currently we are doing a project with an sx 80 and the goal is   to work with the amx panel to control sx 80 instead of touch 10 Currently we can do it by web browser because...

Hi, I have an Expressway design question(s) that I would like some clarity on. Deploying an Expressway install for a customer that has 2 x datacentres with pretty much the same setup in both - the customer will be using MRA and Telepresene.The plan ...

We setup a new extension "3570" and when we assign it to a phone, or multiple phones it shows the name, but also says "To Voicemail" so when we call that number it goes directly to our voicemail system (asking you to put in your pin) Our Voicemail P...

After updating the firmware on our 4501 I can no longer stop/start(make important/non important) content from the bridge like I was able to before.  Now content pushes the whole time if I don't stop sending from the endpoint. Any clue on which settin...

Hi All, Like to check if you all encounter the same issue as me. Recently I have installed Cisco SX80 on a customer site and they have done one-to-one NAT between WAN IP address and internal IP address and have open the ports that are required incl...

I need to do port forwarding on my AT&T U-verse in order to get my Cisco IP Communicator 8.6.2.0 to work properly.  I need the Protocol (TCP or UDP) and Port (or Range) in order to do this.  Any know?  Thanks in advance.  Barbara

I'm trying to incorporate the use of Chroma Key into our VC sessions. I presently use a Cisco C60 and I'm having trouble finding a solution. I have seen few demonstrations of the green screen (also a 3D thingy) from Oslo office but couldn't dig up an...

Is there any particular attributes that TMS used to retrieving the user accounts from AD groups. I have an AD Group imported from TMS and used for webex service. We have total 354 user associated with this group in AD but only 176 users are imported ...

We have a BE6K with CUWL standard users.  We're adding some DX650s and the users want to be able to do: 1) Personal multiparty video conferencing2) External video conference calls For the external calls I just need LIC-EXP-RMS?But what licensing do I...

L-WBX-M-SB-W-N= I have the above part no for cisco Webex meeting centre It allow up to 25 user per host, hence, can form the 25 user make a separate session i.e 2 or more than 7 separate virtual meeting room per host from the 25 user.