TelePresence and Video Infrastructure

Hi all,I have an issue that C20s do not boot up.As soon as we connect an AC adapter to a C20, LED on the front panel lights green (not flashes) but it does not boot up.And no booting message is seen on console.(Boot sequence does not seem to run)So f...

Jabber video 4.6Can't share desktop application that uses direct show for video.I see the note in the release notes about certain applications may not work due to API, or adobe air or gtk+.If the full screen is shared it works most of time but someti...

Good morning,we have here a CUCM (9.1.2.10000-28) installed, upgraded from older version. It is located in an laboratory.Registered Endpoints are :- C20- E20- Jabber Clients- SIP TRUNK to VCSI can do only voice call between all of these clients.I hav...

Hello,We working with:MCU 5310CUCM 8.62We don't have gatekeeperWe register the mcu to the mcu according to the deployment process: http://www.cisco.com/en/US/docs/telepresence/infrastructure/mcu/install_guide/Cisco_TelePresence_MCU_Deployment_guide_1...

How many conferences can I schedule in TMS that will have recording (TCS) automatically connect. Thanks. TMSVersion: 12.6 TCSVersion: S4.1

Is there a way to turn off the layout changes when DTMF tones are used?When we dial into an audio bridge from a room on the 8710, the DTMF tones are causing the screen layout to change. We would like to use FECC only to change screen layouts. (Simila...

Apparently the existing Cisco MCU range 42xx, 45xx, the ISDN gateway 3241 and Content servers (generation 1 and 2) do not support the SRV records method for the definitiion H.323 gatekeeper and SIP Proxy server definition.There is also no room to def...

                   I have a 6 Peer VCS Cluster that shows wrong username or password for each Peer on the Clustering Tab in TMS. I can go to each individual VCS in TMS, click on the Connection Tab and TMS tells me that the username and password is co...

Hi All,I have removed the UnifiedCM servers from VCS 8.1 configuration, and I can see that AUTO created ZONEs for TLS are not deleted.  Consequently when I add Unified CMs to the Unified Communications again, I receive the following error:Failed: Una...

Is it possible to add an extender to the touch panel cable for the EX90? My customer is trying to use the EX90 in a asmall confernece room and needs the touch panel to reach the conference table.

                   Hi Folks,Can Anyone suggest how to take backup for recordings on an external drive from Cisco Content Server.