TelePresence and Video Infrastructure

Hi, I have configured 1000 nos. of Cisco IP phone in my network with CUCM 8.6 and 2951 voice gateway router. If someone wants to communicate with rest of world then all call flow going through reliance PRI Line. I have 12 CO port (FXO Port) in my voi...

I have a 2951 router with 2 7960 phones and a 3550 switch.  I can't get my phones to see the router, and I'm kinda stuck.  Can any one help me pleae?here is my config:CallManager#show runBuilding configuration...Current configuration : 3466 bytes!ver...

Hello all! Firstly, I'm sorry to have to post here. I can assure you I've done my reading on the various posts about this issue and tried to troubleshoot myself with no luck. My situation is probably similar to the other posters on this issue. I'm ne...

Hi all!Some days ago i faced wuth a trouble of making a call from 1 softphone (being Polycom RealPresence Desktop) to another (being the same).endpoints have been registered normaly aka SIP Advanced or Basic with digest authentication. The duration o...

Hi, All! At CTS-SX20-PHD4X-K9 has two video inputs.Can I use them to connect external video cameras? If so, what cameras are supported?

Hi all,I have my Expressway with a public IP and I can see in the logs several call attempts with for example:Source                                                  Destinationsip:205@expressway IP                       sip:xxxxx148355@expressway IP...

All,I have (4) MCUs connected to my Conductor.  All (4) are connected to the same switch on the network.  However only one keeps spitting out these messages in the Conductor Event Log.  Where should I begin to look for this?2013-03-06T11:55:30-05:00c...

Hi experts,we had CTS 3010 whose IP phone on the screen shows the message " Verying Version Compliance -Version Mismatch  contact helpdesk".We had checked the settings from the CUCM and also in the phone.We had even subscribed and unsubscribed the mi...

Hi,Recently I had install Profile 55. Before I connect the touch screen controller into this system. I still able to using the remote control to configure the system. But after I connect touch screen controller, the remote control can not be used any...

As per Business Edition 9.1 ordering guide, virtual VCS control software is now included with Cisco Business Edition 6000 Version 9.X and includes 10 concurrent nontraversal calls and 5 concurrent traversal calls for no additional cost. 1. What is th...