TelePresence and Video Infrastructure

I'm dealing with an odd issue here. I have CUCM 8.6.2a, CTS 1.8, VCS 7.2, TC5.Internal to the network I have EX90s and CTS systems registered to CUCM. CUCM has sip trunk to VCS-Control. VCS control and expressway are connected via traversal zone, and...

Enabled a menupassword on my EX90 now I would like to remove it. I have not found a way to do this in command line? Any Help? on 5.1.7                

I am trying to synchronize users via an external LDAP source in TMSPE. This results in an error showing me in a little rectangular box on the right lower side of TMS window saying "check the logs".Where can I find these logs?(At programms\TMS\TMSProv...

HiI have 12 screen licences for my TelePresence Server v3.0 in TMS scheduled mode registered to the VCS and want to run it in 720p HD but limit the screens to 16, not the full 24 that can be used.  The admin guide doesn't tell me how to limit the ser...

Any one out there have a Cabling diagram for the Profile 42"  for "ALL" cables that connect between the codec to the DNAM and monitor??? I know this is weird but I can't find the connector on the DNAM to the speakers thru the DNAM ???? email is chet....

Hi All,can someone advise if we can create seperate credential for CTS and VC (Tandberg ) end-points other then admin, and if yes, can we set previleges to that new account ( for eg: a new account with user id : test and password test123) ....Thanks

Hi,While trying to restart the system remotely via web access, I get the following screen: (restart is locked and grayed out)In other 2 Cisco units I have (C40 and SX20) I CAN reset remotely)Where is the setup for this and how do I change it?

Hi  all ,I have  installed cisco TMS and VCs control on the central site of custmer. and i have to install the Cisco Jabber for telepresence on the Remote site.The  network routing is not enabled on the remote site  to see each others. the remote sit...