1700 Tandberg - the codec's power light comes on but the continues to flash from amber to green as if it's constantly going through a reboot process. The screen remains black and the remote control has no effect.Any suggestions?Thanks
Hi,We have tms 13.2.1 with several codec enables : C series, ex, mxp, Polycom hdx.The problem is that from few week appears the error "No snmp response" in all codecs. The conectivity to codec is correct, i can make ping and response correctly. The e...
HiWe have severel end points (C40 and 95MXP) with difficulty keeping ISDN/IP calls connected or even connect at all. The calls that goes through disconnect in between 1 - 50 seconds. There's nothing to suggest that the calls are being forcefully di...
Hi All,I am seeing a problem where we have two overlapping two digit numbers (e.g. 12 & 12)12 = Hunt Pilot (Partition-CLI)12 = Translation Pattern to hide CLI (Partition-Hide-CLI)This setup seems to work for most devices but not all. When dialing 12 ...
Hi,How are you?I have a question, can Cisco Jabber Video register to a VCS standalone? or is it necesary also a TMS? on its data sheet it says that a requirement is the TMS but if a customer has a VCS with TP EP registered to it, it wants to enable j...
i have an ex90 for my home business. was wondering if it was possible to use hdmi connection on the ex90 to view movies. i tried and have not had success in getting picutre
Hi Guys,i need a few clarification on stand alone VCS-EX call flow, considering this scenario:Assume that endpoints on corporate wan, are not Cisco Telepresence product ( so we cannot really know if those are h.460\Assent compliant), but all of those...
Thanks ahead of time for the advise and suggestions!Given that the VCS Expressway is the only entrypoint from the outside world into our video conferencing network, what is the best way to deploy and use an MSE8350 IP GW? Do organizations put it outs...
Hello!A customer was concerned that calls to a Jabber client at a remote office were at a higher call rate than what that office's network could handle. I advised them that the Maximum In/Out Bandwidth could be Provisioned for the Jabber client (in ...
Good morning all,Just a quick config question on the Cisco TelePresence C20. At the top of the display at all times is a white bar that shows the IP address, and in the upper right corner there are icons showing a clock and date display as well. Can ...
Hi Have the following installed:* CTS Manager* CUCM* 1x CTMS in South Africa* 1x CTMS in GhanaIs it possible to cascade the two CTMS systems so that all devices in Ghana connects to the one CTMS and all the devices in South africa connect to the Sout...
HiWe have registered Cisco 5310 MCU with CUCM 8.6.1, and its added to MRGL, we need to do Video conferencing with Jabber clients, also we have some C40s and ex60s from these devices also we need to do video conferencing, how can we do this ?Regds$
Dear All,We have 5300 series MCU, ISDNGW and C series endpoints.All endpoints and infra devices are configured with public IP.All endpoints and ISDN call prefix are registered to MCU's builtin GK.In order to prevent unknow registration to MCU GK, we ...
