Unified Computing System Discussions

How should i be etting my my sanboot to my clariion? Its a active/passive array.with with vhbas, fc0 and fc1fc0 goes to fabric A, fc1 going to fabric Bon fabric A, there are 2 spA ports and 2 spB portson fabric B here are 2 spA ports and 2 spB portsw...

Can I connect 2 6248 FIs to an upstream Nexus 5548 (Layer 2 daughter card) for ethernet/LAN connectivity and create a vPC as displayed in the attached pic?

in vsphere why does my vnic shows 40000Mbps. while another host will only show 10000Mbps

Hi,I have one chassis in a UCS 6140 pod that is using 2208 IOM's (all the other chassis use 2104's). This happened due to needing to expand that pod while haveing ony that equipment on hand. Now, I'd like to swap out the 2208 IOM's for 2104's, one at...

Hi!If i use Any configuration as local disk configuration policy and do the raid settings directly to the RAID-cards, am i able to have two raid volumes on C-series under UCSM management?What i would like to do with C240M3 with 6 local disks: 2 disk ...

Hi UCS Community,Curious about use cases for Server Pools. They seem to be suited for quite large UCS installations with tens or hundreds of chassis and blades. Is this the case?We have blades in Server Pools and because of this we can't do something...

Hi,The question is in the title !So, is it possible to know the last reload/reset date or the update time of a server blade B-series ?I could not find this piece of information in the GUI (or via a show command)Many thanksNicolas.          

Does anyone know if UCS B200 M3 supports 1-CPU E5-26xx configuration or any concerns?As I knew, previously B200 M3 with E5 did not support 1-CPU configuration?And I have no clue the reason behind of why it did not support.I would be appreciated and t...

Has anyone started testing Windows 2012 with their UCS?  I have a few RTM servers up and running and I've seen a couple problems so far.  I have them booting from SAN using B230M2 blades with the M81KR card.; that's working fine.  I ocassionally get ...

Hi,I deal mainly with voice stuff and have limited UCS knowledge and am looking for some help troubleshooting issues with a UCS C210 M2 that I have deployed to host some Cisco CallManager and Unity Connection servers.Twice over the past couple of wee...

Should fabric failover be checked when creating vmnics on a service profile? Or should A stay at A and B stay at B?

Dear MentorsHow can i connect Cisco UCS c series C460-M2 server with LTO-5 Tape drives. In 460 there is no SAS HBA. And in LT0-5 there is no FC port. Can i use third party  6GB HBA SAS in 460-M2 server. I think PCI is open standard and logically it s...