Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. Could I check some MX device routing logic please? If an MX in Routed mode, with a WAN1 uplink configured with a public IP address and a gateway as normal, is it possible to configure a 0.0.0.0/0 Static Route on Configure > Addressing & VLANs pag...
Hi,On review of the vMX Setup Guide for Azure, we were disappointed to find that you can't have a vMX in Azure in Routed Mode and do AutoVPN split tunnelling. We can understand why dashboard might need work to enable this (you'd need the table under ...
Hi,I'm being really dumb here, but in the API Reference in DevNet (https://developer.cisco.com/meraki/api-v1/overview/) when using the built-in API browser, how do you set your API Key as the Authorization Global header? It's been a while since I've ...
Hi. Does anyone have any insights into configuring a Privacy Preferences payload for macOS to give an application Full Disk Access (the permission shown in Systems Manager is 'System Policy All Files')? I am trying to do this for Cisco Secure Client ...
Hi,I've had some conflicting information so would appreciate if anyone could confirm please? When configuring Local internet breakout - VPN exclusion rules and using Protocol DNS, if you specify a domain is a wildcard (i.e. all subdomains) implied, o...
Hi. I didn't see this question answered above, apologies if it is covered. I was subscribed to the Firmware Upgrades topic to receive notifications of new firmware releases, will topic subscriptions like this have been carried across and where will t...
No we don't want to use Full Tunnel mode, but documentation says you have to use Full Tunnel mode on a vMX in Azure if you also want to use Routed mode (because the vMX won't advertise subnets). Routed mode is required because the vMX is replacing a ...
Yeah, we're familiar with vMX in Azure in Passthrough mode for AutoVPN connectivity, that's how we've always done them in the past. But a customer has seen vMX can now be in Routed mode, wants to use as a NATing gateway alongside AutoVPN. Not being a...
