Hi guys, Quick question. A friend bought a used SPA112 on eBay, but he can't connect to it through the web interface or the IVR interface.I believe the web interface has been blocked though the UI (Screenshot taken from another SPA112):Then, if tryin...
I have lost my signin and pin information how can I access my messages
I have been using my SPA112 for 8 years without problem. Now, some of my incoming calls are going directly to voice mail. I am told by the callers that the phone does not ring on their end and they have to wait about a minute or more for my answeri...
Hi,i am using Single Number Reach for a short time . But I face a weird behavior that I want to get rid of. When I call someone from my mobile phone and reach the voicemail, If I don't leave a message, the call (on which voicemail is message is runni...
I am working on my Cisco VoIP and when I followed the lab instructions to create a username and password to login to a Cisco 7945, when I attempted to login, I found out I needed Cisco Unified Presence. Is this just "software" I can install on the Ci...
bonjour, j'ai Achter un spa 122 rc chez keyyoet la je change d'operateur et je voudrais modifier les paramètre mais j'ai un souci c'est que je n'arrive pas accéder a l'administrateur avec admin mot de passe adminje n'arrive pas aussi a réinitialisé l...
Hi All,I have an SPA112 and its all configured to work as per my network settings. However, it keeps cutting out the line after every minute. Not sure what the real problem is. I've updated the firmware to the latest..still the same thing...Any thoug...
Hello,We have a UC560 still in production. AT&T detected toll fraud, calls were being made outbound using the main number every second, they were international numbers. So AT&T has shut down our international dialing until we fix the issue. I am not ...
A few weeks ago, we installed a UC540 system for a customer with the SPA 509 ip phones. The customer has 3 Analog lines connecting to the FXO ports to connect to the PSTN. Caller-ID is enabled on the ports. When a call comes in from the PSTN, ...
Hi, I have recently switched our phone system to VOIP and was supplied an SPA122 ATA to connect the old (really old) analog external ringer/bells. Needless to say after connecting the bells, they won't work. I'm assuming there is a compatibility iss...
Hi,When I connect to a mobile or cell phone from my Cisco ATA191 there is a 2 second delay between what one party says to the other party receiving a reply - which ATA191 settings should I check and/or modify to correct this? Landline to landline cal...
issuesspeaker headphone and mute all are blinking so is the message light 3 middle phone lights are a light orange constant nothing on the screen same result with identical phone and that's with just the power line in connecting to internet no differ...
Using an ATA 191 for analog-SIP conversion, we have a fax on line 1 and an analog phone on line 2. We experience following problem on line 2 with the analog phone: once the user finishes dialing (a 2 to 10-digits number), it takes 4 to 5 seconds for ...
Working with a university that has 110 - SPA112 ATA devices deployed across their network, that has been operating without an issue, had all SPA devices connect to the VoIP providers Device management service and pull a bad configuration file and loa...
