Voice Systems and Accessories - Small Business

we just bought spa8800 series gateway 4fxs with 4 fxo port. And found there is no option to set NAT mapping enable "No" however does allow to set for Phone 1 but for other lines its "Yes" by default and does not allow to set.We did try to disable by ...

I need to assign a static IP address to a SPA508g phone.  We have multiple locations and Our President wants a phone in one of our remote locations connected to our Headquarters.  All of our sites are connected via 2600 routers over an MPLS.  I have ...

Is this the only way non-business users can get support? There are a number of issues I need to report to Cisco which would help them improve their products but seems I would have to pay a fortune in order to do so... is there any other way that retu...

Does UC 540 support Primary NI2?

I have a 509G in SIP on asterisk (trixbox). Is it possible to create a button that will blind transfer to an extension? I am basically looking to make a one touch park button. The user would hit it and the phone would initiate a blind transfer to ext...

<Idle_Key_List ua="na">resume|1;psk1|2;dir|3;redial;lcr</Idle_Key_List>Identical config works on SPA525 and amazingly it also works on a 502G

HII am installing a UC560 into an office with 24 extensions they want to have a common address books that when a call comes in, the Persons Name apprears on the 79** phones rather than their number They had a similar system with  alcatel where each e...

I currently have a UC520 in a home office with 3 phones and desktops connected to it. But I also have an office in a shop at the other end of the property, around 700 feet away.We have had a Cat5 ethernet cable linking the 2 sites for the past few ye...

I wish to setup speed dials at a system level that will be available to all DN's. Our that can be asscoaited to one Group. Can this be done.

Hello,We have a UC520 with CCME 4.2 and CUE 3.0.3 our problem is that we have an auto attendant that plays a couple of options back to the caller to be redirected to the proper person. our problem comes, options 4 and 6 always swap for no reason, we ...

HelloI have 2 call manager with inter-cluster trunk, Call Manager A 6.1 y B 4.1(3), from call manager A is working with IPCC 6.0 the call manager A has configure a CTI Route point for the Contac Center with the extension 2000, the thing is that we ne...

guys,i am having problem with the vpn setup. i am able to ping from a to b, but no the other way around. i have checked my access-list and vpn setup, and also reboot the unit, and no luck. any idea?when i look at the access-list on site b, is shows t...